Publicidad
Idiomas disponibles
Idiomas disponibles
AIR SUPPLY
Tools operate on a wide range of air
pres sures. It is recommended that air
pressure mea sures 90 PSI at the tool
with the trigger fully depressed and no
load applied to the tool. Low pressure
(under 90 psig; 6.2 bar) re duc es the
speed of all air tools. Low air pressure
not only wastes time, but also costs
money. Higher pres sure (over 90 psig;
6.2 bar) raises performance beyond the
rated capacity of the tool, which will
LUBRICATION
Lubricate the air motor daily with
NAPA air tool oil. If no air line oiler is
used, run 1/2 oz. of oil through the
tool. The oil can be squirted into the
tool air inlet or into the hose at the
nearest con nec tion to the air supply,
then run the tool. The oil plug is only
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MAN U AL FOR FUTURE REF ER ENCE.
6-1156
short en tool life and could cause injury.
The rec om mend ed hookup pro ce dure
can be viewed in the above figure.
Always use clean, dry air. Dust, corro-
sive fumes, and/or water in the air line
will cause damage to the tool. Drain the
air tank daily. Clean the air inlet filter
screen at least once per week.
The air inlet used for connecting the air
supply has standard 1/4" NPT American
for adding multi-purpose grease after
repair or maintenance of the impact
mechanism. Overfilling will cause a
re duc tion in the power of the tool.
WARNING: After an air tool has been
lubricated, oil will discharge through
the exhaust port during the first few
3
Thread. Line pressure should be
increased to compensate for unusu-
ally long air hoses (over 25 feet).
Minimum hose diameter should be
3/8" I.D. Fittings should have the same
inside dimensions and should be tight-
ly secured.
Ensure an accessible emergency shut
off valve has been installed in the air
supply line and make others aware of
its location.
seconds of operation. The exhaust port
must be covered with a towel before
applying air pressure to prevent serious
injury.
Rev. 05/22/23
Publicidad
