Publicidad
Idiomas disponibles
Idiomas disponibles
POLO 2.0
TURNING ON
CAUTION: A small amount of deflagra-
!
tion may occur on the burner when
igniting and when switching off the
device. This does not constitute a fault with the
device and is no cause for alarm. Always keep a
sufficient distance from the burner.
Open the regulator valve.
1.
Press the regulator button (F) until the small flam
2.
symbol appears and at the same time continuously
press the piezo-ignition button (G). After successful
ignition, keep the regulator button pressed for
another 10 seconds. This brings the burner up to the
necessary operating temperature.
TURNING OFF
1. To switch of the device, close the regulator valve.
PROBLEM:
Q The patio heater does not ignite.
Q There is a gas smell.
The rare case that the heater does not ignite after
3.
the piezo-ignition button has been pressed 4 or 5
times, repeat the procedure after 2 minutes.
NOTE:
The
be ignited by other means of ignition
(candle lighter, long match) through the side of the
glow grille. Wear gloves and keep a safe distance
from the burner! Caution, accessible parts can be
extremely hot. Keep away from children
SYMBOL EXPLANATION
high/low setting
SOLUTION:
The patio heater contains a tilt prevention device,
Q
making possible to encapsulate the gas feed can
in a globe during transportation. In order to acti-
vate the gas feed, shake the burner head lightly to
propel the globe back to its original position and
ensure a proper supply of gas.
Do not use the device if there is a gas leak. The gas
Q
supply must be shut off if this occurs during use.
Check the device and replace damaged parts befo-
re using it again.
9
546033
device
can
also
Piezo ignition
(G)
Control knob
(F)
220510
Publicidad
