LAVOR Pro DTV100 1-55 SL Libro De Uso Y Mantenimiento página 28

Replacement of primary fi lter
1. Release and lift the cover
2. Remove the dust bin (see paragraph 16)
3. Access to the fi lter from the below part (pic.5) of the vac-
uum (where the dust bin was located), remove the pins
that keep fi lters and lever for fi lter cleaning together
4. Lift the fi lter
5. Unscrew the bolt (B) with an Allen key
6. Remove 6 plastic ties (C)
7. Unscrew the metal clamp (D) and remove the fi lter from
the metal ring
8. Replace the fi lter with the one correct for the vacuum.
(refer to the price list)
9. Insert the new fi lter on the metal ring (D) and screw the
metal clamp
10. Fit the basket into the fi lter keeping the round plate at
the external, screwing with the nut and the bolt (B)
11. Set the fi lter sewn stitches using new plastic ties (C)
12. Check the integrity of the rubber gasket on the metal
ring and insert it with the fi lter into the fi lter chamber
13. Insert the pins (pic.A) between the fi lter shaker lever and
the round plate. Insert the pin (pic.1)
Replacement of the secondary HEPA fi lter
1. Release and lift the cover
2. Unscrew the knob and take out the washer
3. Replace the fi lter with a new one (refer to the price list)
4. Fit the new fi lter, keeping the washer rubber side in touch
with the bottom of the fi lter and screw again the knob
(pic. F)
WARNING: THE SUBSTITUTION OF THE FILTER MUST BE CARRIED ONLY BY PERSONNEL AUTHORIZED EACH
NON AUTHORIZED SUBSTITUTION AND / OR MAINTENANCE OF FILTERING SYSTEM CAN COMPROMISE
THE SAFETY OF APPLIANCE, IN THIS CASE THE PRODUCER DECLINES EVERY RESPONSIBILITY.
14. FILTER REPLACEMENT
28
1
2
B
C
D
F
A