Publicidad
Idiomas disponibles
Idiomas disponibles
Too much washing detergent can cause
excessive quantities of foam and could
have an adverse effect on the washing
and rinsing process. Insufficient washing
grey. In order to prevent this, it is advis-
able to first place the washing detergent
in the detergent dispensing drawer and
then the softening agent.
Washing detergent dispensing drawer
The washing detergent should be mea-
sured and placed in the appropriate com-
washing programme commences.
In order to do this, pull open the deter-
Compartment 11
for the main
Washing detergent in powder form
position. It is set to this position in the
the detergent manufacturer inside the
Liquid washing detergent
If liquid washing detergent is used, the
flap in com partment 11 must be set to the
vertical position @. In order to do this,
pull out the detergent drawer as far as
remove it completely @. Press down the
flap in compartment 11 until it clicks into
again.
Fabric conditioner
Use the appropriate quantity of fabric
u re r.
If the conditioner is very thick, it is advis-
able to dilute it with water before use in
order to ensure that it is dispensed com-
pletely into the washing machine. The
cates the maximum filling level. At the
end of the washing programme a small
amount of water will remain in the fabric
-
conditioner compartment of the drawer.
Starch
Use as you would fabric conditioner
(compartment III)
b) Starch in powder form:
used as indicated by the manufacturer;
place in compartment I.
machine
Select the washing programme from the
programme table (note care symbols in
the garments). Set the programme selec-
tor to the required washing programme.
Set the desired spin speed. If necessary,
select any additional functions. Then
press
the start button.
8
Publicidad
