Courtyard Creations TGS40SV Instrucciones De Armado

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS40SV-CS01
2
TGS40SV-CS02
3
62TGS40SVY101
4
17C17A0403001YX
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #7)
- Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic holders
on the underside of the table top (#1) rim. Fasten
them together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
!
assembled.
!
Do not sit or stand on this table.
!
Do not discard of any of the packaging until you have checked that you have all the parts and pack
of fittings.
Keep children away during assembly. This item contains small parts which can be swallowed by
!
children. Children should always be under direct adult supervision while using this product.
! Retain the assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
TGS40SV
PART Q'TY
1
TABLE TOP
4
LEG
1
CENTER CONNECTOR
4
SCREW ST4.2*12
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO THE STORE!
STOP
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
5
17C40A0705001YX
6
17FC05020601-YX
7
17KAA0101----Y4
8
17KAC3101----Y3
FIGURE 1
2
2
1
COURTYARD CREATIONS INC.
PART Q'TY
8
BOLT M6*15
8
WASHER d6.5*D10*1.6
1
HEX. KEY WRENCH 4MM
1
HEX. KEY WRENCH 10MM
2
2
4