Publicidad
Idiomas disponibles
Idiomas disponibles
installation
& Assembly
The air compressor
should be turned off, unplugged
from
the power source,
the air bled from the
tank and the unit allowed time to cool before any maintenance
is performed.
Personal
injuries could
occur from moving parts, electrical
sources,
compressed
air or hot surfaces.
The quick connect
as-
sembly
must be attached
before use. Failure to assemble
correctly
could result in leaks and possible
injury. If unsure of assembly
instructions
or you experience
difficulty in the assembly
please
call our
toll free number for assistance.
Assembly
1. Remove air compressor,
manual, air filter
assembly, and accessories from packaging.
2. Remove the plastic plug from the compressor
intake port. (see diagram below)
3. Install the filter in the compressor
intake port.
(see diagram below)
4. Remove the oil fill cap from the crankcase and
fill until the oil reaches the top of the red dot in
the sight glass. Oil capacity is 3 oz. (see below)
Use SAE-30 non-detergent semi-synthetic oil
(API CG/CD heavy duty motor oil). Under
extreme cold weather conditions use SAE-10
weight oil.
5. Replace the oil cap.
Estimated
Assembly
Time:
Approximately
5 minutes
Grounding
Instructions
This product should be grounded.
In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for the electric current. This product is equipped
with a cord having a grounding wire with an ap-
propriate grounding plug. (See the figure below.)
The plug must be plugged into an outlet that is
properly installed and grounded in accordance
with all local codes and ordinances.
Check with
a qualified electrician
or service personnel if
these instructions are not completely
understood
or if in doubt as to whether the tool is properly
grounded.
Plug
Grounded
.....
Outlet
Grounding Pin
Getting
Started
-
Location
of the Air Compressor
The air compressor
should always be located
in a clean, dry and well ventilated environment.
The unit should have at minimum, 12 inches of
space on each side. The air filter intake should
be free of any debris or obstructions.
Check the
air filter on a daily basis to make sure it is clean
and in working order.
NOTES
4
Publicidad
