Publicidad
Idiomas disponibles
Idiomas disponibles
● Keep fingers AWAY from trigger when not
driving staples to avoid accidental firing.
● Do not use the electrical cord if damaged. Have it
repaired immediately.
● Choice of triggering method is important. Please
read and understand "METHOD OF OPERATION"
found below.
● Before starting work, check the stapling
operation switching device. This metabo HPT
stapler includes a stapling operation switching
device. Before starting work, make sure that the
switching device is properly set. If the switching
device is not set properly, the stapler will not
operate correctly.
● Never place your face, hands or feet near firing
head when using.
● Do not drive staples on top of other staples or
with Stapler at too steep of an angle; staples can
ricochet and hurt someone.
● Do not drive staples into thin boards or near
corners and edges of workpiece. Staples can be
driven through or away from workpiece and hit
someone.
● Never drive staples from both sides of a wall at
the same time. Staples can be driven into and
through the wall and hit a person on the opposite
side.
● Never use Stapler which is defective or operating
abnormally.
● Do not use Stapler as hammer.
● Remove all remaining fasteners and battery from
stapler when:
1) doing maintenance and inspection;
2) checking proper operation of push lever and
trigger;
3) attaching or removing the nose cap;
4) cleaning a jam;
5) it is not in use;
6) leaving work area;
7) moving it to another location; and
8) handing it to another person.
● Remove battery from Stapler when:
1) loading staples;
2) turning the adjuster.
Explanation of the stapling operation
○ SINGLE SEQUENTIAL ACTUATION MECHANISM:
First, press the push lever against the wood; next, pull
the trigger to drive the staple.
After stapling once, stapling will not be possible again
until the trigger is released and pressed again.
METHOD OF OPERATION
This Stapler is equipped with the push lever and does not
operate unless the push lever is depressed.
There is a method of operation to drive staples with this
Stapler.
They are:
1. Intermittent operation (Trigger fire):
WARNING
To avoid double firing or accidental firing due to
recoil.
1) Pull the trigger rapidly and firmly.
(1) Position the staple outlet on the workpiece with finger
off the trigger.
(2) Depress the push lever firmly until it is completely
depressed.
(3) Pull the trigger to drive a staple.
(4) Remove finger from the trigger and lift the tool off the
wood surface completely.
To continue stapling in a separate location, move the
stapler along the wood, repeating steps (1)–(4) as
required.
NOTE
Operations (2) and (3) should be done within
4 seconds of each other. If more than 4 seconds pass
after (2), the Stapler will not work properly. If this
happens, retry from (2).
Push lever
WARNING
A staple will fire each time the trigger is
depressed as long as the push lever remains
depressed.
English
(2)
Trigger
(3)
19
Publicidad
