Descargar Imprimir esta página

Milwaukee 2482-20 Manual Del Operador página 5

Lijadora de banda de 13 mm x 457 mm (1/2' x 18') y lijadora de banda de 10 mm x 330 mm (3/8' x 13') m12 fuel

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Push the arm against a hard surface until the
safety latch clicks into the locking position.
4. Remove the belt from the drive and contact
wheels.
5. Fit the replacement belt over the drive wheel and
contact wheel.
6. Ensure the belt is centered on the contact wheel.
7. Release safety latch using the release button on
the arm as shown below.
8. Rotate the belt guard back into position, and turn
the thumbscrew clockwise.
Installing/Changing the Contact Wheel
1. Remove battery pack.
2. Unfasten the thumbscrew.
3. Push the arm against a hard surface until the
safety latch clicks into the locking position.
4. Rotate the belt guard out of the way and remove
the belt.
5. Press the safety latch until the arm springs back
to its original extended position.
6. Unfasten the screw with a flat head screwdriver.
7. Remove and replace the contact wheel.
8. Apply removable thread locker on the threads of
the screw and then tighten the screw.
9. Install the belt and align belt on drive wheel and
contact wheel.
10. Rotate the belt guard into the closed position and
tighten the thumbscrew.
5

Publicidad

loading

Este manual también es adecuado para:

2483-20