Publicidad
Idiomas disponibles
Idiomas disponibles
XQG6S-SS_ - M_UAL I0/22/0111:34AM _
2O
leveling
Your Washer
• Your washer
has 4 leveling
legs; which are located
on the four
bottom
corners,
After properly
placing
your washer
in its final position,
you can level your washer.
• Leveling
legs can be adjusted
by turning
them counterclockwise
to raise your
washer
or turning
them clockwise
to lower your_
Steps
for
Installation
h,_h J" -- -4 o_
Select a suitable
location
for this appliance
on a hard even surface away from
direct sunlight
or heat source e.g. radiators,
baseboard
heaters,
cooking
appliances
etc. Any floor
unevenness should
be corrected
with the leveling legs located
under-
neath,
on the bottom
corners.
This appliance
must be placed
at room temperature.
You must not place this appliance
where the temperature
is at below
freezing.
Installing
Your Washer:
Read install instructions
carefully
before
installation,
Caution:
If, after completing
these steps, you are unsure that unit is properly
installed,
contact
a qualified
installer.
To ensure that your appliance
is
properly
installed
it is recommended
that it be installed
by a certified
installer.
1, Insert a new flat washer
into each end of the inlet hoses. Firmly put the washers
in the coupling.
Note:
You may have to use pliers to tighten
the coupling.
Do not over tighten
because you may cause damage
to the valve.
2. Connect the hot and cold water
inlet hoses to the hot and cold water faucet.
3. Connect the other end to their respective
washer
inlet located
at the rear.
19
Publicidad
