Publicidad
Idiomas disponibles
Idiomas disponibles
Slide the saw blade 6 into the guide rollers 7
♦
with the saw teeth pointing upwards. Make sure
that the guide rollers 7 firmly grip the saw
blade 6.
NOTE
►
Make sure that the direction arrow on the
saw blade 6 (if any) is the same as the one
on the rubber wheels u.
Place the saw blade 6 around the two rubber
♦
wheels.
the saw blade clamping lever 8
♦
Retighten
by turning it anticlockwise
Replace the protective cap t.
♦
WARNING! RISK OF INJURY!
►
Do not operate the appliance without the
protective cap t fitted!
♦
Perform a test run by briefly switching the appli-
ance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
►
Keep your body away from the sawing
area during the test run!
Getting started
Switching the appliance on/off
Switching on:
♦
Press the safety lock-out 2 and keep it pressed
and then press the ON/OFF switch 3.
After starting, the safety lock-out 2 can be
♦
released again.
The LED work light a lights up when the ON/
♦
OFF switch 3 is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off:
♦
Release the ON/OFF switch 3.
PMBA 20-Li B2
again.
Setting the rotational speed
Adjust the speed adjustment wheel 1 to a
♦
position between 1 and 6.
Working procedures
♦
Secure the workpiece against slipping, e.g.
with a vice.
♦
Use the weight of the saw when sawing. Do not
exert any additional pressure.
♦
Wait until the saw has reached its full speed
before carefully bringing it into contact with the
workpiece.
If the saw blade 6 blocks, switch off the appli-
♦
ance immediately.
Do not twist the saw blade 6 while making
♦
the cut.
WARNING! RISK OF INJURY!
►
Do not remove the workpiece until the saw
has come to a standstill.
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■
Store the appliance and the saw blades in a
dry and dust-free location.
■
The appliance must be kept clean and free
of oil or grease.
■
Use a dry cloth to clean the housing.
■
Never obstruct the ventilation openings.
■
Use a brush to remove any sawdust that has
stuck to the appliance.
NOTE
►
Replacement parts not listed (such as switches
or saw blades) can be ordered via our
Service Hotline.
GB │ IE
│
9
■
Publicidad
