Publicidad
Idiomas disponibles
Idiomas disponibles
KIT SEK 100W - SEK 100W
EN
SAFETY INSTRUCTIONS
Warning! When using electric tools basic safety precautions should be followed to reduce the risk of fire,
electric shock, and personal injury. Read the entire manual before attempting to operate the soldering gun.
Save this manual.
1. Keep work area clean.
Cluttered areas and benches invite injuries.
2. Consider work area environment.
Never expose power tools to rain. Do not use power tools in damp or wet locations. Keep work area well lit.
Don't use power tools near flammable liquids or gasoline.
3. Guard against electric shock.
Prevent body contact with grounded surfaces (pipes, radiators, ranges, refrigerators) when open operating
power tools.
4. Keep children away from power tools.
Do not let anyone contact the tool or the power cord. Keep all visitors out of the work area. Keep out of
reach of children. This appliance is not intended for use by persons (including children), with physical,
sensory or mental capacities are impaired, lack of experience or knowledge, unless they have supervision
or instruction concerning the use of the appliance by a responsible person for their safety.
Children should be supervised to ensure they do not play with the appliance.
5. Store idle tools.
When not in use, tools should be stored in a dry, out of reach, or locked location, away from children.
6. Do not force tool.
It will operate move efficiently and safer at the normal rate it was designed for.
7. Use right tool.
Don't force small tools to do the job of heavy tools. Operate tools for intended use only.
8. Dress Properly.
Do not wear loose clothing or jewelry. They may become caught in moving parts. Rubber gloves and
non-skid footwear are recommended when working outdoors. Wear a protective hair covering to
contain long hair.
9. Use proper safety glasses.
If necessary, use a face shield or dust mask.
10. Don't abuse cord.
Never carry the tool by the cord or yank it out of a power receptacle. Keep cord away from heat, all liquids,
and sharp edges.
11. Do not force your working position.
Keep proper footing and balance at all times.
12. Maintain tools with care.
For safety and performance, keep tools clean and sharp. Follow regular maintenance procedures. Inspect
tool cords and extension cords periodically. If damaged, use a certified service technician to repair. Keep
handle dry, clean, and free from grease or oil.
13. Disconnect tools.
Disconnect when not in use, servicing, or performing maintenance.
14. Avoid unintentional starting.
Never carry a plugged in tool with your finger on the switch. Turn switch off before plugging it in.
15. Extension cords.
When working outdoors, use outdoor rated extension cords.
16. Stay alert.
Use common sense. Pay attention to your work. Do not operate tool when overtired.
17. Check for damaged parts.
Before using, check the tool for damaged parts to insure safe operation. Check alignment of moving
parts, for broken parts, binding of moving parts, proper mounting, and any conditions that might affect
safe operation. Any guard or part that is damaged should be replaced or repaired by a authorized service
technician. Do not use the tool if switch does not turn on or off properly. Have defective
switches replaced by an authorized service technician.
16
Publicidad
