GE AGM06 Manual De Instrucciones página 15

Troubleshooting Tips. GEAppliances.co
Troubleshooting -tips.Save time and money/. Review the chart below
first and you may not need to carl for service.
Possible Causes
Aircond#ioner The air conditioner "Make sure tile air conditioner phtg is pushed completely
does notstart is unplugged,
into the outlet.
The fuse is blown/circuit • Check the house fl/se/circuit breaker box
and replace
breaker is tripped, the fl/se or reset the breakeI:
Power failure. •/f power taihu'e occurs, turn the air conditioner
OFF.
_'hen l)ower is restored, wait 3 minutes to restart the
air conditioner to prevent tril)ping of the compressor
()verload.
The current interrupter • Press the RESETbutton located (m the power cord plug.
device is tripped. •/t the RESETbutton will not stay en,_zwed discontinue
use ot the air conditioner and contact a qualified service
tech nicia n.
Air conditioner does not Airflow is restricted. • Make sure there are no curtains, blinds or flu'niture
cool as it should bh wking the fl'_mt of the air c_mditione_:
The temp control may not • On models with touch pads: ]n COOL mode, press the
be set correctly.
DECREASE Vl)ad.
• On models with control knobs, turn the temperature
knob to a higher numbe_:
The air f'flter is dirty. • Clean the filter at least eve U 30 days.
See the
OperatingInstructions
secti_)n.
The room may have been hot. • _A]wn the air conditioner is fi_st turned on, you need to
allow time fin" the room to cool down.
Cold air is escaping. • (_he(k fi)r open flu'na(e floor registe_ and cold air returns.
• Set the
air conditioner's vent to the closed l)osifion.
Cooling
coils have iced up. • See "Air
conditioner freezing lip"
below.
Air conditioner Ice blocks the air flow and • On models with control knobs, set the mode control at
freezing up stops the air conditioner HIGH FAN or HIGH COOL with the temp at I or 2.
from cooling the room.
• On models with touch pads, set the controls at
HIGH(F3)FANor HIGH(F3)COOL and set the thenn ostat
to a higher temperature.
What To Do
The remote control The batteries are inserted • Check the position of the batteries. They shotfld be
is not working
incorrectly, inserted in the opposite (+) and (-) direction.
The batteries may be dead. • Replace the batteries.
Water drips outside Excessively hot and • This is nom_al.
hmnid weather.
Water drips indoors The air conditioner is not • For l)roper water disposal, make sure the air conditioner
tilted to the outside, slants slightly i]'om the case fl'ont to the re:u:
Water collects in
basepan
Moisture is removed from
indoor air and drains into
rear of a cabinet where a fan
blows it against the outdoor
condenser coil.
• This is no_mal fi>r a short period in areas Mth little
humidity; nom_al fi>r a longer period in ve_ T humid areas.
TIMERfeaturenot
workingproperly
A power outage or interruption
occurred,
• In the case ota power outage or interruption, the unit
HMERteature will reset to the original setting. Ybu may
need to set a new time if desired.
15