Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits from forming
in essential
fuel system parts such as carburetor, fuel
filter, fuel hose, or tank during storage.
Also, alcohol blended fuels (called
gasohol or using ethanol or methanol)
can attract moisture which leads to
separation
and formation
of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage.
1.
Drain the fuel tank.
2,
Start the engine and let it run until the
fuel lines and carburetor are empty.
• Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer is an acceptable
alternative in minimizing the formation
of
fuel gum deposits during storage. Add
stabilizer to gasoline in fuel tank or
storage container. Always follow the mix
ratio found on stabilizer container. Run
engine at least 10 minutes after adding
stabilizer to allow the stabilizer to reach
the carburetor. Do not drain the gas tank
and carburetor
if using fuel stabilizer,
ENGINE
OIL
Drain oil (with engine warm) and replace
with clean engine oil. (See "ENGINE"
in
the Maintenance
section of this manual).
CYLINDER
1. Remove spark plug.
2.
Pour one ounce (29 ml) of oil through
spark plug hole into cylinder.
3.
Pull starter
handle slowly a few times
to distribute
oil.
4.
Replace
with new spark plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts to rust. Rust and/or dirt in your
gasoline will cause problems.
• If possible, store your unit indoors and
cover it to protect it from dust and dirt.
• Cover your unit with a suitable protec-
tive cover that does not retain moisture.
Do not use plastic. Plastic cannot
breathe, which allows condensation
to
form and will cause your unit to rust.
IMPORTANT:
Never cover mower while
engine and exhaust
areas are still warm.
CAUTION:
Never store the lawn mower
with gasoline in the tank inside a building
where fumes
may reach an open flame or
spark. Allow the engine to cool before
storing in any enclosure.
TROUBLESHOOTING
- See appropriate
section
to a Sears Service Center.
in manual unless directed
PROBLEM
CORRECTION
Does not start
CAUSE
1. Dirty air filter,
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark
plug wire is
disconnected.
6. Bad spark plug.
7. Loose
blade or broken
blade
adapter.
8. Control
bar in released
position.
9. Control
bar defective.
10.Fuel
valve lever (if so
equipped)
in OFF position.
11.Weak
battery
(if equipped).
12.Disconnected
battery
connector
(if equipped),
13.Engine
control
lever is
in STOP position.
1. Clean/replace
air filter,
2.
Fill fuel tank.
3.
Drain tank and refill with
fresh, clean fuel.
4.
Drain fuel tank and
carburetor
and refill tank
with fresh gasoline.
5. Connect
wire to plug.
6.
Replace
spark plug.
7. Tighten
blade bolt or
replace
blade adapter.
8.
Depress
control
bar to
handle.
9.
Replace
control
bar.
10.Turn
fuel valve lever
to the ON position.
11 .Charge
battery.
12.Connect
battery to engine.
13.Place
engine control lever
in FAST position.
17
Publicidad
