Tascam BD-MP1 MK II Manual Del Usuario página 26

Preparing the remote control
Installing batteries
1.
Open the cover on the back.
2.
Insert two AAA batteries, being certain to use the correct ¥
and ^ orientations.
3.
Close the cover.
When to replace batteries
Replace both batteries with new ones if the distance from the
main unit that the remote can be used decreases or if the unit
stops responding to the remote buttons.
Battery precautions
Misuse of batteries could cause them to leak or rupture, for
example. Carefully read and follow the battery caution labels.
(see "CAUTIONS ABOUT BATTERIES" on page 6)
Using the wireless remote control
See "Wireless remote control (TASCAM RC-BDMP1MKII)" on page
13 for the button functions.
When using the remote control, point it toward the receiver on
the unit and use it within the range shown below.
Remote control signal receiver
Remote control operation range
From any angle within 15° of front: 5 m
ATTENTION
o Operation might not be possible if there are obstacles.
o Remove the battery if not using the remote control for a long
time (a month or more).
o It battery fluid should leak, wipe away any fluid inside the
case thoroughly and install a new battery.
o When using other devices that can be controlled by infra-
red rays, operation of this remote control could cause those
devices to function improperly.
26
TASCAM BD-MP1MKII
Turning the unit on and putting it
into standby
NOTE
When this unit is connected by a power cord and electricity
is supplied from an outlet, it will automatically start up. (This
will also occur when power is restored after a power outage
or other interruption to the power supply.)
Turning the unit on
If the STANDBY/ON indicator on the front of the unit lights red,
press the button or the remote control STANDBY/ON button.
HELLO
Startup screen
BDMV
Operation screen
After the unit starts and the startup screen is shown, the opera-
tion screen will appear on the display.
Putting the unit into standby
Press the button on the front of the unit or the remote control
STANDBY/ON button to put the unit into standby.
ATTENTION
Do not turn the power off or disconnect the power cord when
the unit is operating (including playing back or writing data
to a USB flash drive). Doing so could damage the unit.
Loading and removing discs
Loading discs
Press the OPEN/CLOSE (-) button on the main unit or remote
control.
Open the disc tray and place the disc on it with the label side up.
Press the OPEN/CLOSE (-) button again to close the disc tray.
After loading a disc, the unit will read its information and show
the media type on the display.
NOTE
When the disc tray is open, "OPEN" will appear on the display.
When the disc tray is open, "CLOSE" will appear on the display.
Ejecting discs
Press the OPEN/CLOSE (-) button on the main unit or remote
control.
After the disc tray opens, pick the disc up by its center and
remove it.
NOTE
The OPEN/CLOSE (-) button functions when the unit is
turned on.