Teac T-H300 Manual Del Usuario página 11

Troubleshooting
Problem Probable cause(s)
Suggested remedy
No sound.
INPUT SELECTOR of amplifier is not set to
"TUNER".
Select "TUNER' in INPUT SELECTOR.
VOLUME of amplifier positioned in "MIN".
Adjust VOLUME accordingly.
The terminal for system connection is
pulled out.
Connect the terminal for system
connection correctly.
Only noise is heard.
The antenna is pulled out.
Connect the antenna on the rear panel.
The frequency is not detected exactly.
Set the frequency correctly.
Broadcasting is received but with noise.
The position of antenna is not suitable.
Install the antenna again after locating
the best reception position.
The power of CD is turned on. Turn off CD.
The preset call buttons on the remote
control do not work.
The remote control is set to a mode other
than tuner.
Select tuner on the remote control.
-1-
ENG