Scheppach MBS1200xt Traduccion Del Manual De Instrucciones Originale página 31

18. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not work
The engine runs slowly
and does not reach the
operating speed.
Motor makes excessive
noise
The motor does not
reach its full power.
Motor overheats easily.
Saw cut is rough or
wavy.
Workpiece pulls away
and/or splinters.
Burn marks on the
wood when working.
Saw band jams when
working.
Possible cause
Engine, cable or connector defective,
fuses burnt.
Voltage too low, coils damaged,
capacitor burnt.
Coils damaged, motor defective
Circuits in the network are overloaded
(lamps, other motors, etc.)
Overloading of the motor, insufficient
cooling of the motor
Saw band dull, tooth shape not appro-
priate for the material thickness
Excessive cutting pressure and/or
saw band not suitable for use.
Saw band blunt.
Incorrect speed.
Saw band blunt.
Saw band resinous.
www.scheppach.com
Remedy
Have the machine checked by a specialist.
Never repair the engine yourself.
Danger! Check the fuses and replace them if
necessary.
Have the voltage checked by a utility provider.
Have the engine checked by a specialist.
Have the capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other equipment or engines on
the same circuit.
Avoid overloading the engine while cutting.
Remove dust from the engine in order to
ensure optimal cooling of the engine.
Sharpen the saw band or insert a suitable saw
band.
Insert a suitable saw band.
Replace the saw band.
Choose a suitable speed for the workpiece to
be cut.
Replace the saw band.
Clean the saw band.
GB | 31