Kicker KB6000 Manual De Instrucciones página 3

Use the mounting bracket as a template to mark the mounting
holes on the mounting surface. Make sure there is adequate
room to tighten the locking knobs on both sides of the
mounting bracket before you pre-drill the mounting holes. Use
a 7/64" (2.5mm) drill bit when using the supplied black coated
stainless steel mounting screws, then screw the mounting
bracket to the mounting surface.
3
B
3
B
2011 KB6000 Rev D.indd 3 2011 KB6000 Rev D.indd 3
1
Unscrew the locking knobs on both
sides of the speaker mounting bracket.
included
screws
3
A
2
Position the KB6000 enclosure,
loosely fasten the locking knobs,
adjust the angle of the speaker
and then tighten the locking knobs
once you have the desired listening
angle.
If the supplied hardware is not applicable
to your installation, some other means
of securely attaching the speakers to
the vehicle or mounting location must
be used. The threaded inserts on the
top, bottom and back of the KB6000
are 1/4"-20 (.25 inches in diameter,
20 threads per inch), and may be
used with other mounting systems to
customize your installation. You are solely
responsible for securely fastening the
enclosure.
11/10/2010 2:41:41 PM 11/10/2010 2:41:41 PM
3