Hoover HWPD 414AMBC/1-S Manual De Instrucciones página 64

Setting
l
The washing machine should be installed in
its final position such that the water fill hose
is not kinked or trapped. The corrugated
drain hose should be inserted into suitable
drain pipe of between 50 cm and 85 cm
height above the floor using the curved drain
hose support. If an under sink connection is
used the drain hose must be routed above
the sink overfill opening to prevent back
siphoning. Care must be taken to avoid
kinking or trapping the drain hose (fig. 7).
l
Level the appliance using the feet as
illustrated in figure 8:
a. turn the nut clockwise to release the
screw;
b. rotate the foot to raise or lower it until it
touches to the floor;
c. lock the foot, screwing in the nut, until it
tightens against to the bottom of the
washing machine.
l
Plug in the appliance.
WARNING:
contact the Customer Service Centre
should the power
replacement.
Installation faults are not covered by
the manufacturers warranty.
*
ACCESSORY SOLD SEPARATELY
cord need
64
7
+2,6 mt
max
min 50 cm
max 85 cm
8
B
C
min 4 cm
A