Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION:
NOTE:
When the projector is properly connected to the mains, the following
information appears successively in the display during the startup process:
"Software Update, Please Wait..." (for service purposes only), the software
version "Software V1.xx" and "WELCOME TO cameo". After this operation,
the projector is ready for use and changes to the mode that was previously
selected.
STATIC COLOUR
This mode offers the ability to separately adjust the intensity for each of
the 6 LED groups and to generate an unlimited number of different colours
(colour mixing).
Press the MODE button repeatedly until "STATIC" appears in the upper line
of the display. By repeatedly pressing the ENTER button, select the LED
group for which you want to change the brightness level (please note the
cursor in the display, Rxx = red, Gxx = green, Bxx = blue, Wxx = white,
Axx = amber, UVxx = UV / black light). Now you can set the intensity of the
selected light from 00 to 99 using the UP and DOWN buttons (example: R00
= red at 0%, i.e. out. R99 = red at 100%, i.e. maximum brightness).
Adjust the flash frequency of the strobe effect by pressing on ENTER repeatedly
until the cursor shows "Fxx". Now you can activate the strobe effect using the UP
and DOWN buttons and set the flash frequency from 00 to 99 (F00 = strobe effect
deactivated, F01 = approx. 1 Hz, F99 = approx. 20 Hz). Confirm with ENTER.
RED
Intensity R00 - R99
GREEN
Intensity G00 - G99
BLUE
Intensity B00 - B99
WHITE
Intensity W00 - W99
AMBER
Intensity A00 - A99
UV / BLACK LIGHT
Intensity UV00 - UV99
STROBOSCOPE
Speed F00 - F99
8
Publicidad
