Publicidad
Idiomas disponibles
Idiomas disponibles
Original accessories/auxiliary
equipment
■
Use only the additional equipment and acces
sories specified in the operating instructions.
Using attachments or accessory tools other than
those recommended in the operating instruc-
tions can lead to a risk of injury .
Before use
Selecting a sanding sheet
Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sandpaper .
■
Please note that you need to use appropriate
sandpapers with different grains for working
different materials .
Materials:
Wood (sanding sheets included in the delivery),
paints*, stone*
*Depending on the sanding sheet
Changing sanding sheets
The appliance has a Velcro sheet that enables fast
and simple changing of the sanding sheets .
WARNING!
►
Always remove the plug from the mains power
socket before carrying out any work on the
appliance .
Attachment:
♦
You can attach the sanding sheet
sanding plate
using the Velcro .
Make sure that the holes on the sanding sheet
match up with the holes on the sanding plate
Removal:
♦
Lift the sanding sheet
off the sanding plate
NOTE
►
Before fitting a new sanding sheet
any dust and dirt from the sanding plate
PDS 290 C3
to the
on one side and pull it
to remove it (see fig . b) .
, remove
.
Turning the sanding plate in 60°
increments
WARNING!
►
Always remove the plug from the mains
power socket before carrying out any
work on the appliance .
♦
Turn the sanding plate
in 60° increments until it clicks into the desired
position (see fig . C) .
Removal and surface:
The shape of the delta sander makes it easier to
sand in hard-to-reach places, corners and edges .
The material removal rate and surface quality are
determined by the grain strength of the sandpaper
and the set oscillation speed .
■
Please note that you need to use appropriate
sandpapers with different grains for working
different materials . Also adjust the speed
depending on the material .
Working procedures
■
Switch the appliance on before applying it to
the workpiece .
■
Apply minimal pressure when working .
■
Work at a constant speed .
■
Change the sanding sheets regularly .
■
Never sand different materials (such as wood
and then metal) using the same sanding sheet
Optimum sanding results can only be achieved
by using clean sanding sheets .
■
Clean the sanding sheet
while using a vacuum cleaner .
.
on the delta sander
.
every once in a
GB │ MT
│
35
■
Publicidad
