General Instructions - SPORT-ELEC BODY BEAUTIFUL Manual De Uso

III. GENERAL INSTRUCTIONS
A / ELECTRODES FUNCTION
This function allows using the adhesive electrodes by connecting them to the unit.
STEP 1 : ELECTRODES CONNECTION
Take the electrodes and remove carefully their protection. (photo 1 A page 3).
Body Beautiful is composed of 2 groups of 2 90 cm long wires ending in 2 groups of 2 connecting plugs (2 green & 2 orange plugs).
Connect the electrodes with the connectors of the device (photo 1-B page 3).
STEP 2 : ELECTRODES POSITIONING
Fit the electrodes on your body as shown in diagram 2. page 3 (Positions are shown for information only).
Fasten your SPORT-ELEC® belt to the back of your clothing or underwear using its clip.
Examples of electrodes positioning (see 2 page 3) :
= connector of channel A (orange connector),
A - Pectoral muscles A - Shoulders
1 2
1 - Major pectoral 2 - Middle deltoid
Do not place electrodes in 3 - Front
the cardiac area 4 - Back
STEP 3 : PROGRAM IN PROGRESS
Start your unit following the "Starting the unit" procedure described in paragraph II.
Contractions should be firm but never painful.
If you feel an unpleasant sensation around the electrodes : bring the power-on key back to minimum, move the electrode(s) and
gradually increase the power.
Once the adjustments have been optimised in this way, let your appliance works for the full duration of the program.
STEP 4 : DISCONNECTION
Once the program is finished, disconnect the electrodes from the unit.
Then pull off the electrodes gently, dampen them slightly with a few drops of water, then return them carefully onto their support.
Store the adhesive electrodes in a fresh location, in a plastic bag (e.g. vegetable container in the refrigerator).
B / BELT FUNCTION
The multifunction belt can be used whole, or separated into 2 to form 2 half-belts.
The full belt must be used on the stomach, buttocks, lower back areas.
Once unfastened, the 2 "half-belts" can be used on the arms, thighs, or calf.
The multifunction belt has built-in electrodes on which the SPORT-ELEC® cream is applied.
This cream enhances contact between the electrodes and the skin.
Its massaging and electro conducting properties improve comfort of use and enhance stimulation.
The cream can also be used for body massage.
If you want to buy the SPORT-ELEC® cream, please order directly by going on www.sport-elec.com, or contact your local supplier.
Never use the belt without the cream provided.
Do not use any cream other than the one provided by SPORT-ELEC® INSTITUT.
SAFETY PRECAUTIONS FOR CREAM USE
• In case of allergy, stop applying the cream.
• Do not swallow.
• Do not leave with the range children.
• In case of contact with eyes rinse with water.
PRESENTATION OF THE BELT :
• Front side : (photo 3. A page 4)
- Fasteners - Wire storage - Connection terminals
• Electrodes side : (photo 3. B page 4)
4 built-in electrodes
14
= connector of channel B (green connector)
B - Trapezius C - Back
9 - Upper trapezius
11 - Main back muscles
10 - Middle trapezius
- Scratch strip
STEP 1 : CONNECTING AND FITTING THE BELT.
1 - Check your SPORT-ELEC ® unit is stopped.
2 - Take the connectors of your device and connect them to the belt connectors per groups of two (photo 3. C page 4).
3 - Apply a thick layer of electro-conductive massaging cream onto the electrodes built into the belt (domed part - photo 3. D page
4)
4 - Place the belt or 2 half-belts onto the zone(s) to be stimulated, and adjust them using "scratch" strips to ensure the built-in
electrodes are properly in contact with the skin (photos 5. page 4 : A - stomach, B - back, C - arms, D - thighs, E - calf )
Move the belt slightly left or right (with device powered off ) to feel the contractions on the abdominal area.
If an electrode hurts or if you feel any tingling, stop the device, and check the electrode is properly smeared with cream.
TIP :
• Fitting the full belt (photos 4. A page 4) :
To position the full belt at best, cross the 2 strips to flip the 2 ends on the outer scratch part.
• Fitting the half-belt on the arm (photos 4. B page 4) :
Adjust at the belt mid-size, according to the outline of your arm before positioning it, then start over if necessary to ensure proper
adjustment.
STEP 2 : STARTING THE BELT FUNCTION
Once your unit is connected, install yourself comfortably and start your unit using the procedure "Starting the unit" detailed previ-
ously in paragraph II.
STEP 3 : STOPPING THE BELT FUNCTION
Once the program is finished, disconnect the device from the belt.
Remove the excess cream on the built-in electrodes using a wipe dampened with water, then dry them.
IV. RECOMMENDATIONS OF USE
The unit is recommended for physiotherapists for functional re-education.
- You can restart a program's cycle on another muscle zone or change the program while remaining on the same muscle zone,
without exceeding however 40 min use per muscle zone and per day.
- For optimum use, refer to the diagrams shown in this leaflet.
- Clean the unit and its cables with a cloth dampened with a disinfecting solution (mercryl type) diluted in water at 1/10th.
- The adhesive electrodes can be rehydrated before and after use with a disinfecting agent (e.g. hexamedine).
- The adhesive electrodes must be repositioned on their support, and stored in a fresh storage between +5°C and +10°C.
- The adhesive electrodes have a lifetime of about 40 uses, you can order them directly from the company headquarters, or on on
the SPORT-ELEC® website, or also from your reseller.
SPORT-ELEC® INSTITUT - B.P. 35 - 31 rue du Val Breton - 27520 BOURGTHEROULDE - FRANCE
Tel. 00 33 2 32 96 50 50 - Fax. 00 33 2 32 96 50 59 - www.sport-elec.co.uk - info@sport-elec.com
• Use only on those parts of the body for which the accessories were designed.
• Functions only on batteries.
• Not to connect to another source of power.
PRECAUTIONS OF USE
• Do not use on cardiac area.
• Do not use the unit on your face
• Do not leave within reach of children
Ask for advice from your physician :
- if you have electronic or metallic implants (pins, etc.)
- in case of skin condition (wounds,...)
RECOMMENDATIONS :
Please apply regulations enforced in your country when
disposing your product at its end of life.Therefore, please
discard it in a location planned to this effect, ensuring it is
disposed in an environment-friendly manner.
15