Whirlpool W7 MW541 SAF Manual página 12

CLEANING
Make sure that the appliance has cooled down
before carrying out any maintenance or cleaning.
INTERIOR AND EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth. If
they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Clean the glass in the door with a suitable liquid
detergent.
• At regular intervals, or in case of spills, remove the
turntable and its support to clean the bottom of
the oven, removing all food residue.
• Activate the "Smart Clean" function for an
optimum cleaning of the internal surfaces.
• The grill does not need to be cleaned as the
intense heat burns away any dirt. Use this function
on a regular basis.
TROUBLESHOOTING
PROBLEM
The oven is not working.
The oven makes noises, even when it is
switched off.
The display shows the letter "F" followed
by a number.
The oven does not heat up.
PRODUCT FICHE
The product fiche with energy data of this
WWW
appliance can be downloaded from Whirlpool
website docs . whirlpool . eu
HOW TO OBTAIN THE USE AND CARE GUIDE
> Download the Use and Care Guide
WWW
from our website docs . whirlpool . eu (you
can use this QR Code), specifying the
product's commercial code.
> Alternatively, contact our Client After-sales Service.
12
POSSIBLE CAUSE
Power cut.
Disconnection from the mains.
Cooling fan active.
Software fault.
When "DEMO" is "On" all
commands are active and menus
available but the oven doesn't
heat up. DEMO appears on display
every 60 seconds.
Never use steam cleaning equipment.
Do not use wire wool, abrasive scourers or
abrasive/corrosive cleaning agents, as these could
damage the surfaces of the appliance.
ACCESSORIES
All accessories are dishwasher safe with the exception
of the Crisp plate.
The Crisp plate should be cleaned using water and
a mild detergent. For stubborn dirt, rub gently with
a cloth. Always leave the Crisp plate to cool down
before cleaning.
SOLUTION
Check for the presence of mains electrical power and
whether the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Open the door or hold or wait until the cooling process has
finished.
Turn off the oven and restart it to see if the problem persists.
Try to perform the "FACTORY RESET", selectable from
"SETTINGS". Contact you nearest Client After-sales Service
Centre and state the number following the letter "F".
Access "DEMO" from "SETTINGS" and select "Off".
CONTACTING OUR AFTER-SALES SERVICE
You can find our contact details
in the warranty manual. When
contacting our Client After-sales
Service, please state the codes
provided on your product's
identification plate.
XXX/XXX
XXXXXXXXXXXX
XXXXXXXXXXXX