Leggett & Platt FLIGHT M Guia Del Usuario página 2

Press and hold to turn the flashlight ON. Release the
button to turn the flashlight OFF.
Press to turn on/off underbed light feature.
Press and hold to raise or lower the head section.
Press to adjust the base to the factory default snore position.
To reprogram, adjust the base, massage, and underbed light
to the desired position, then simultaneously press and hold
the Set button and Snore button until an audible sound is
heard, then release both buttons.
ZG (ZERO GRAVITY) BUTTON
Press to adjust the base to the factory default ZG position.
To reprogram, adjust the base, massage, and underbed
light to the desired position, then simultaneously press and
hold the Set button and ZG button until an audible sound is
heard, then release both buttons.
HEAD MASSAGE INCREASE BUTTON
Press to turn on head massage. Press again to increase
massage intensity. Massage turns off automatically after
HEAD MASSAGE DECREASE BUTTON
Once head massage is turned ON, press to decrease massage
intensity. Once massage is at the lowest intensity, press again
Press to turn massage on in wave mode. Press
again to cycle through wave speeds.
TO CLEAR PROGRAMMED SETTINGS AND REVERT BACK TO FACTORY SETTINGS, SIMULTANEOUSLY PRESS AND HOLD THE
REMOTE CONTROL REQUIRES (3) AAA SIZE BATTERIES. TO CONSERVE BATTERY LIFE, THE TRANSMITTER
2
REMOTE CONTROL FUNCTION
FLASHLIGHT BUTTON
UNDERBED LIGHT BUTTON
HEAD UP/DOWN BUTTON
SNORE BUTTON
15 minutes.
to turn massage OFF.
WAVE BUTTON
ZG, SNORE, AND MEMORY BUTTONS:
HEAD DOWN BUTTON AND FLAT BUTTON UNTIL AN AUDIBLE SOUND IS HEARD, THEN RELEASE BUTTONS.
TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON IS PRESSED FOR MORE THAN 50 SECONDS.
LOCK BUTTON
To lock / unlock the remote control buttons, press and hold lock
button for 5 seconds. Backlight will flash 3 times.
DUAL UP BUTTON
Press and hold to simultaneously raise the head and foot sections.
FOOT UP/DOWN BUTTON
Press and hold to raise or lower the foot section.
HEAD FOOT
FLAT BUTTON
FLAT
Press to lower the base to the level position.
This button also turns off massagers.
SNORE ZG MEM
MEMORY BUTTON
Press to adjust the base to the factory default memory position.
SET
To reprogram, adjust the base, massage, and underbed light to
the desired position, then simultaneously press and hold the Set
H F
button and Memory button until an audible sound is heard, then
WAVE
release both buttons.
MASSAGE
FOOT MASSAGE INCREASE BUTTON
Press to turn on foot massage. Press again to increase massage
intensity. Massage turns off automatically after 15 minutes.
FOOT MASSAGE DECREASE BUTTON
Once foot massage is turned ON, press to decrease massage
intensity. Once massage is at the lowest intensity, press again
to turn massage OFF.
SET BUTTON
Use to program ZG, Snore, and Memory presets.
NOTE