Leggett & Platt FLIGHT M Guia Del Usuario página 3

1
Plug base into power outlet.
NOTE
AN ELECTRICAL SURGE PROTECTION DEVICE
IS RECOMMENDED (NOT INCLUDED).
3
Operate the remote control to verify
the base functions correctly.
1
Plug both bases into power outlet. Operate each
base to verify the base functions properly.
Lower both bases to the flat position.
IF BASES DO NOT RESPOND, REVERT BACK TO 1-TO-1 PROGRAMMING.
3
Plug one end of the sync cable into the sync port (on the control box) of base 1. Plug
the other end of the sync cable into the sync port (on the control box) of base 2.
SYNC
PORT
BASE 1
CONTROL
BOX
6
Operate the remote control(s) to verify both bases function correctly. If using only one remote
control to operate both bases, store the second remote for use as a spare.
TO REVERT BACK TO 1-TO-1 PROGRAMMING, REMOVE SYNC CABLE FROM CONTROL BOXES.
REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE
2
Simultaneously press and hold both the HEAD DOWN and FOOT UP buttons on the remote control.
While holding these buttons, press and hold the LEARN button on the control box or the PAIR button
on the in-line switch, as equipped. Hold until you hear an audible sound, then release all buttons.
HEAD
DOWN
REMOTE CONTROL PROGRAMMING - 1 OR 2 REMOTES TO OPERATE 2 BASES
NOTE
SYNC
CABLE
NOTE
FOOT
UP
HEAD FOOT
FLAT
SNORE ZG MEM
SET
H F
WAVE
MASSAGE
2
UNPLUG both bases. Place both bases on their sides close to each other.
DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO
SYNC
PORT
SYNC
CABLE
CONTROL BOX
ELECTRICAL
POWER CORD
PAIR
BUTTON
CAUTION
!
HANDLE AND MOVE ADJUSTABLE BASE.
4
Turn both bases over onto their legs.
!
MAKE SURE SYNC CABLE IS NOT
CAUGHT IN BASE OR PINCH POINTS.
5
Plug both bases back into power outlet.
AN ELECTRICAL SURGE PROTECTION DEVICE
IS RECOMMENDED (NOT INCLUDED).
LEARN
BUTTON
IN-LINE
SWITCH
CAUTION
NOTE
3