Korg KingKORG NEO Manual Del Usuario página 14

KingKORG NEO Owner's Manual
Selecting a program
The KingKORG NEO contains 200 distinctive programs that you can
start playing immediately. So that you can select them intuitively,
the programs are organized by categories of sound. Try selecting
and playing various programs to experience the KingKORG NEO's
sound.
1 .
Selecting programs by their number
1.
Press the PROGRAM (GLOBAL)button to make it light up.
The main display will indicate the program number and program
name.
2.
Turn the value dial to select the desired program.
TIP: Programs for which the SPLIT (POSITION) button is lit up
have their voice mode set to split. (PG: "2. Timbre param-
eters")
3.
Play the keyboard to hear the sound.
You can use the OCTAVE UP/DOWN
buttons to shift the range of pitches that can
be played from the keyboard. (OM: p.15
"Switching octaves")
Selecting programs by category
1.
Press the category/favorites button that most closely matches
the program (sound) you want.
The first program in the selected category will be selected, and
that category/favorites button will light up.
2.
Turn the value dial to select the desired program (sound).
3.
Play the keyboard to hear the sound.
2 .
Selecting programs with the
FAVORITES button
In order to select programs using the FAVORITES button, you
must first have stored your favorite programs in the category/
favorites buttons. (OM: p.22 "3. Registering programs in the
category/favorites buttons")
1.
Press the FAVORITES button to make it light up; then select a
bank (A–E).
The bank will change each time you press the FAVORITES
button, and the main display will show the selected bank.
TIP: By holding down the SHIFT/EXIT button and pressing the
FAVORITES button you can move backward through the
banks (E à D à C à B à A à E...).
2.
Press the category/favorites button (1–8) in which you stored
the program that you want to select.
The program will be recalled, and the selected FAVORITES
screen will light up.
14
3.
Play the keyboard to hear the sound.
Adding variety to the sound
In addition to its keyboard, the KingKORG NEO provides numerous
controllers such as the joystick, knobs, and buttons. You can vary the
sound by using these controllers to control the filter, LFO, and EG in
real time while you play.
Using the controllers
Joystick (JS)
You can control various parameters and effects by moving the
joystick in four directions (up/down/left/right). The result will be
different for each program; try each controller to hear what it
does for the program you've selected.
TIP: "Joystick" is abbreviated as JS.
−X
Pitch down, etc.
TIP: When you release the joystick, it will automatically return
to the center position. However if you want to hold the
joystick effect so that it will continue even after you take
your hand off the joystick, you can assign the joystick lock
function to a foot switch. (PG: "8. Foot parameters")
TIP: You can use the joystick as a virtual patch source. This
lets you obtain even richer and more complex effects than
those listed above. (PG: "2. Timbre parameters")
Playing the keyboard
The KingKORG NEO's keyboard lets you control the sound in the
following ways.
Velocity
This allows the force (speed or velocity) of how you play a key
to affect the sound. Normally, key velocity is used to control the
tone or volume.
The KingKORG NEO's keyboard does not support
aftertouch. Some sounds will produce little or no tonal
variation in response to key velocity, or are set not to
detect velocity.
Keyboard tracking
This allows the sound to be affected by the note's position on the
keyboard. Normally, keyboard tracking is used to make the tone
become brighter as you play higher on the keyboard, or to create
a difference in volume between low and high regions of the
keyboard.
TIP: Velocity and keyboard tracking can be used as a virtual
patch source. (PG: "2. Timbre parameters")
+Y Vibrato depth,
effect depth, etc.
+X
Pitch up, etc.
−Y Effect depth, etc.