Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 11
F
D
C
INTAKE
PORT CAP AND
HOSE ASSEMBLY
r!lw_,l..i t t [€.!
MAKE CERTAIN THE DUST COLLECTOR
IS
DISCONNECTED
FROM THE POWER SOURCE.
Fig. 13
A
E
4,
Attach the upper support bracket (C) to the hole (D)
in the intake support brace with the adjustable lock-
ing lever (E). Place M8 lock and flat washers (F) onto
locking lever bolt before attaching to the intake
support brace.
See figure 11.
Fig. 12
........................
1,
Slide the collar (A) of the intake port cap (B) over
intake port (C). Make sure the collar is position to
the back if you intend to attach the hose at this
time. See figure 13.
2.
Place 4-inch hose clamp (D) onto the end of 4-inch
flexible hose (E). See figure 13.
5,
..-..- H
Place intake funnel assembly (G) onto lower sup-
port tube (H) and tighten tube clamp (I) securely.
See figure 12.
3.
Slide end of 4-inch flexible hose with 4-inch hose
clamp onto intake port and tighten securely.
IMPORTANT: When connecting a flexible hose to
intake port, DO NOT REMOVE THE INTAKE PORT
CAP COLLAR
FROM THE INTAKE PORT. Slide the
collar further back when attaching a flexible hose.
12
Publicidad
