Publicidad
Idiomas disponibles
Idiomas disponibles
FOR OPERATOR
SAFETY, keep fingers a ndallforeign
objects o utoftheintake ports. Therotating faninside
theblower housing isaccessible through t heintake
ports andishazardous. Donotwear l oose clothing o r
jewelry. Make certain t hateach intake p ort w hich isnot
being used orattached toa dust c ollection system is
covered w ithanintake p ort c ap.
CONNECTING
TOOL
TO
POWER
SOURCE
A separate electrical circuit should be used for your
tools. This circuit should not be less than #14 A. W. G.
wire and should be protected with a 15-amp time lag
fuse. Have a qualified electrician repair or replace dam-
aged or worn cord immediately. Before connecting the
motor to the power line, make certain the switch is in
the "OFF" position and be sure that the electric current
is of the same characteristics
as stamped on the motor
nameplate. All line connections should make good con-
tact. Running on low voltage will damage the motor.
DO NOT EXPOSE THE DUST COLLECTOR TO RAIN
OR OPERATE THE MACHINE IN DAMP LOCATIONS.
ON/OFF
SWITCH
Fig. 17
A
/
\
The ON/OFF switch assembly is located on the side of
the motor. To turn the dust collector "ON", move the
switch (A) up to the "ON" position.
To turn the dust
collector "OFF", move the same switch down to the
"OFF" position. See figure 17.
LOCKING
SWITCH
IN THE
"OFF"
POSITION
When the Dust Collector is not in use, the switch key
(B) should be removed so that it cannot be started.
Grasp the switch key and pull it out of the switch
assembly. With the switch key removed, the switch
will not operate.
However, should the switch key be
removed while the dust collector is running, it can be
turned "OFF", but cannot be restarted without inserting
the switch key. See figure 17.
TRANSPORTATION
AND STORAGE
IV!lvltl__l:i _I I _[_1
MAKE CERTAIN THE DUST COLLECTOR
IS
DISCONNECTED
FROM THE POWER SOURCE.
Fig. 18
A
1. The dust collector features a convenient carrying
handle with rubber grip (A). See figure 18.
Fig. 19
2.
In addition to the carrying handle, the dust collector
features two storage mounting holes (B). See figure 19.
IMPORTANT: The dust collector weighs approximately
481bs. Care should be taken when lifting and transport-
ing dust collector. Remove collection bag before lifting
to reduce tripping hazard.
14
Publicidad
