Power Dynamics Professional Audio PDSM100 PA Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
FRONT PANEL
1. ON/OFF
Press to turn the device on/off. When turned on, the LED will be illuminated.
2. ASSIGN
Use to select the input source for channel 1 (line or mic).
3. GAIN
Rotate to adjust the microphone input level.
4. MICROPHONE INPUT
Balanced XLR microphone input connector.
5. LED INDICATORS
LED signal- and clip indicators. The signal LED will be illuminated when a signal is detected at the input
connector. The clip indicator will be illuminated in case the channel is being overloaded. If so, turn down
the level.
6. ST2 / AUX
Rotate to adjust the levels sent from each channel to ST 2 / AUX bus.
7. ST 1
Rotate to adjust the levels sent from each channel to ST 1 bus.
8. LED INDICATORS
LED indicators showing the output level of the corresponding channel. The clip
indicator will be illuminated in case the channel is being overloaded. If so, turn
down the level.
9. MONO
Press to select mono mode for the corresponding channel.
10. VOLUME
Rotate to adjust the channel output volume level.
11. OUTPUT SELECTOR
Use to determine the output mode. Button released (bounced) means ST 1 is selected. When pressed, ST 2/AUX is
selected.
12. HEADPHONE VOLUME
Rotate to adjust the headphone output volume level.
13. HEADPHONES OUTPUT
3.5mm and 6.3mm jacks for connecting stereo headphones.
REAR PANEL AND BOTTOM CONTROLS
1. ST 2/AUX OUTPUT
XLR and RCA stereo line outputs for ST 2/AUX channel.
2. ST 1 OUTPUT
XLR and RCA stereo line outputs for ST 1 channel.
3. GND (GROUND)
Signal ground connector (no electrical safety GND).
4. GROUND LIFT
Ground lift switch. Ground connection can be lifted by setting the switch to the left position. The lifting is also effective when
the device is grounded via the GND terminal.
5. ASSIGN
Use to determine where the incoming signals from the master bus input are routed to. (ST 1, ST 2 or both).
6. ST 2 OUTPUT
6.3mm balanced line output jacks.
7. MASTER BUS INPUT
6.3mm balanced line input jacks. The input signal can be routed to ST 1, ST 2 or both
with the assign switch.
8. LEVEL SELECTOR
Switch to set the nominal level for the corresponding channel (-10dB or +4dV).
3