ABB ACS580-04-505A-4 Instrucciones De Instalacion Y Puesta En Marcha página 12

12 EN – Quick installation and start-up instructions
value at 25 °C or 77 °F). For the insulation resistance of other motors, consult the
manufacturer's instructions.
Note: Moisture inside the motor casing will reduce the insulation resistance. If you
suspect moisture, dry the motor and repeat the measurement.
1000 V DC,
> 100 Mohm
EN
DE
Install the drive module into an enclosure
ES
See Step-by-step drawings for an installation example (page
FR
Step Task
IT
1 Install the punched section to the back of the cabinet frame.
TR 2 Take the pedestal guide plate from the bottom of the drive module.
3 Install the support rials and pedestal guide plate to the cabinet bottom frame.
4 Install the telescopic insertion/extraction ramp to the pedestal guide plate.
5 Option +B051: Remove the sheeting from the clear plastic shrouds from both sides.
6 Install the fastening bracket to the drive module.
7 Option +B051:
• Install the bottom grille to the drive module if there is no bottom plate in the
cabinet and degree of protection of IP20 is needed for the drive module from
the bottom side.
• Install the top metallic shroud to the drive module.
• Install the back shrouds to the drive module.
8 To prevent the drive module from falling, attach its lifting lugs with chains to the
cabinet frame.
9 Push the drive module into the cabinet along the telescopic insertion/extraction
ramp.
10 Remove the ramp.
11 Attach the drive module to the pedestal guide plate.
12 Attach the drive module from its top to the pinched section at the cabinet back.
Note: The fastening bracket grounds the drive module to the cabinet frame.
Connect the motor cables and install the shrouds
See Step-by-step drawings for an installation example (page
diagram, see figure G.
ohm
U1
U1-PE, V1-PE, W1-PE
M
V1
3~
W1
PE
129).
129). For the connection
Figure
B
C
D
E
F