Athena GET SX1 CONTROLLER Guia página 7

ATTENTION: If LC-GPA is installed as an accessory, the control unit follows the indications of
the values set with LC-GPA. The control unit is equipped with a Recovery function which, in the
event of breakage and/or malfunction of the LC-GPA, continues to apply the set values until
the engine is started up the next time;
*Function not available for KTM, HUSQVARNA, GASGAS Cross 125 and Enduro 150 cc models.
LAUNCH CONTROL ACTIVATION*
The Launch Control functionality is available and settable for both maps.
To activate it, press the
button corresponding
MAP 1
to the desired mapping
(MAP 1 or MAP 2) for
approximately
seconds:
MAP 2
As soon as the rider closes the throttle when entering a curve, Launch Control mode will automatically
turn off.
WARNING:
it is possible to activate the "Launch Control" mode only with the engine running at idle speed.
*Function not available for KTM, HUSQVARNA, GASGAS Cross 125 and Enduro 150 cc models.
two
7
When the function
activated, a flashing RED
L will appear. The triangle
corresponding to
selected map (MAP 1 or MAP
2) will also light up in red:
when the Launch Control
strategy is operating (when
leaving the gate) the map
indication triangle begins
to flash.
is
the
EN