Descargar Imprimir esta página

OHAUS Endeavor 5000 Guia Del Usuario página 8

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
EN-6
Load Error
Uneven / excessive
E4
tray loading, high
vibration, motor
overload
*In the event a foot (suction cup) has come loose from the bench top, the unit may register an errant
E4 error message due to the instability of the unit. Reset the power switch to clear this error. Firmly
press down on the four (4) corners of the unit, creating a strong suction to the work surface (do not
place on bench mat).
4.2
Service Information
If the troubleshooting section does not resolve your problem, contact an authorized OHAUS Service Agent.
For Service assistance in the United States, call toll-free 1-800-672-7722 ext. 7852 between 8:00 AM and
5:00 PM Eastern Standard Time. An OHAUS Product Service Specialist will be available to assist you.
Outside the USA, please visit our website www.ohaus.com to locate the OHAUS office nearest you.
5.
TECHNICAL DATA
Equipment Ratings:
Indoor use only
Altitude: 0 to 2000m
Operating temperature: -10⁰C to 40°C
Storage temperature: -20 to 65°C
Operating Humidity: 20 to 80% relative humidity, non-condensing
Storage Humidity: 20 to 80% relative humidity, non-condensing
Electrical Supply: 24VDC, 1.25A. (For use with certified or approved power supply, which
must have a SELV and limited energy output.).
Voltage fluctuations: Mains supply voltage fluctuations up to ±10% of the nominal voltage.
Overvoltage category (Installation category): II
Pollution degree: 2
Note: For product specifications, please refer to the full Instruction manual by scanning the QR code at the
front cover.
Uneven / excessive loading, loose suction cup foot*,
mechanical obstruction
Toggle the rocker switch to clear this error. Reduction of load /
even load distribution may resolve this error. Alternatively,
disabling the Overload Detection feature may resolve this
fault, please see the Instruction Manual for entering the Menu
and disabling this feature.
If the E4 error persists, remove power from the unit and
contact an Ohaus representative for repair. End user should
NOT attempt repair.
TM
Endeavor
Light Duty Shaker

Publicidad

loading