Descargar Imprimir esta página

Optimus CC-200ETH8 Manual De Instalación Y Funcionamiento página 6

Controlador de conexiones tcp/ip para sistemas optimax2

Publicidad

Idiomas disponibles

Idiomas disponibles

4. PLACEMENT OF THE BATTERY
The PA Manager software allows you to create message schedules and volume schedules, and to send these schedules to the
equipment. In this way, it is not necessary to use a server PC to activate the time schedules, but the equipment activates them
automatically.
For this purpose, the unit incorporates a RTC (Real-Time Clock) whose function is to maintain the current time. To keep the RTC
powered even if the equipment is turned off, a 3V lithium battery type CR2032 supplied with the equipment must be used.
It is advisable to replace the battery of the device at least every 5 years.
Safe handling with batteries:
Warning! Improper use of battery may lead to explosion. Replace the batteries with the same or equivalent type only.
Batteries may endanger life if swallowed. If a battery is swallowed, seek medical assistance immediately.
Before inserting the batteries, check whether the contacts in the device and batteries are clean and, if necessary, clean
them.
Only use new batteries.
Do not use rechargeable batteries
Never try to recharge normal batteries. There is a risk of explosion!
Never expose batteries to heat sources (e.g. radiators) or direct sunlight. There is an increased risk of leakage!
Never short-circuit the batteries.
Never throw batteries into a fire.
Do not disassemble or deform batteries.
If the equipment is not going to be used for long periods, remove the battery.
Remove leaking batteries from the device immediately. If battery acid leaks out it is essential to avoid contact with the skin,
eyes and mucous membranes! If the acid does come into contact with skin, immediately rinse the affected areas with plen-
ty of clear water and
Remove exhausted rechargeable battery from the device immediately! There is an increased risk of leakage.
Do not throw used batteries into the household waste. The batteries must be deposited in a collection point for used bat-
teries.
Battery placement procedure
1)
Disconnect the power supply to the device.
CC-200ETH8 Version 6.0.001
CC-200ETH8
consult a doctor immediately. There is a risk of acid poisoning and acid burns!
:
Figure 3
R+D Department
TCP/IP connections controller
for Optimax2 system
6

Publicidad

loading