cecotec BOLERO SQUAD V 3001 Manual De Instrucciones página 47

First use
Important
- The surface of the ceramic hob must be cleaned as described in the cleaning and
maintenance section.
- Switch on both cooking zones for 5 minutes at maximum power, but do not switch them
on simultaneously. Place a saucepan half full with cold water in each zone. This will help
to eliminate any new odours and evaporate any moisture that may have formed in the
heating elements during transport.
- Do not switch on both cooking zones at the same time.
3. INSTALLATION
Electrical connections
Before connecting the appliance, make sure that the supply voltage indicated on the product
marking corresponds to your mains voltage.
Warning
- This appliance must be connected to an earthed socket.
- If the mains cable is to be replaced, the earthing conductor (yellow/green) must always
be 10 mm longer than the line conductors.
- Make sure that the temperature of the power cable does not exceed 50 °C.
- If the power cable is damaged, it must be replaced by the manufacturer or the official
Cecotec Technical Support Service to avoid any potential risk.
Before installing the ceramic hob
Figure 2 shows the dimensions required for the recess in which the ceramic hob is to be
installed.
Warnings
- Surfaces in direct contact with the plate must be heat resistant (min. 95 °C).
- The appliance can be installed on a worktop with a thickness between 30 and 40 mm and
close to walls that are higher than the worktop, maintaining a minimum distance of 100
mm.
- Make all relevant cuts in the surface/countertop and then carefully remove any shavings
or sawdust before fitting the hob.
- To ensure correct ventilation of the hob, respect the dimensions indicated in figures 2 and
3.
- Make sure that the surface is level and square and that no parts interfere with the space
required for installation.
- Cut as shown in figures 2 and 3.
ENGLISH
BOLERO SQUAD V 3001
47