Mounting And Demounting Attachments - Efco D - BC Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembling trimmer head (Fig.4)
For dismantling the trimmer head (C), put the
head fixing pin (A) in the appropriate hole (B)
and loosen the head clockwise by hand.
en
For assembling the head (C), reverse the
sequence described after put the upper flange
(F) in place.
Assembling the blade (Fig. 5)
WARNING - To use the blades with the
brush cutters must be purchased the kit p.n.
61370224 which comprises:
1) cutting attachment guard (to fit in place of
that supplied)
2) safety boom (to be mounted under the loop
handle)
3) blade
4) lower flange
5) cup
6) nut
Remove the skirt from the cutting attachment
guard before assembling the blade.
Fix the blade (D) onto the upper flange (F)
making sure that the rotation direction is correct.
WARNING:
C, Fig.5) must locate in blade's
mounting hole.
Fix the lower flange (E), the cup (B) and tighten
nut (A) anti-clockwise.
Put the pin provided in the appropriate hole (L)
to block the blade and allow the nut (A) to be
tightened to 18 ft lb (25 Nm).
Assembling the safety boom (Fig. 5A)
When using the disc instead of nylon line head,
it is necessary to set up the "safety boom".
Fix the boom (A) under the attachment (C) of
handle by means of the screws (B). Taking care
to verify the "safety boom" being on the left side
of the brushcutter.
WARNING: Arrows on the cutting
attachment guard show the correct
direction of rotation of the cutting
tool.
12
ASSEMBLY
Collar
(see
arrows
WARNING! This machine is not
suitable for use with disc for wood
(22-60-80 teeth) and relevant metal
guard.
WARNING: Fit the blade protection
(M) p.n. 4196086 as shown (Fig.3)
before transporting or storing the
brush cutter.
CAUTION: Never use the brush
cutter without the cup (B, Fig.5) to
avoid damages to the thread.
WARNING: Never touch or adjust
the blade while the motor is
running. The blade is very sharp,
always wear protective gloves
when performing maintenance.
WARNING: After use the bevel
gear may be very hot, always wear
protective gloves when performing
maintenance.
M O U N T I N G
A N D
ATTACHMENTS (FIG.6)
Mounting:
- Loosen coupling (E) by turning knob (C)
counter-clockwise;
- Align attachment tab (B) with channel (A) in
coupling (E);
- Fit attachment tube (D) into coupling (E) as
far as broken line (F);
NOTE To facilitate the procedure rotate the
attachment cutting tool to engage the drive
shaft with the fitting. Check to ensure there
is no dirt or debris in the coupling;
- Tighten knob (C) fully by turning it clockwise.
Demounting:
Release the coupling by turning knob (C)
counter-clockwise and remove the attachment.
D E M O U N T I N G

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido