Troubleshooting; Using Troubleshooting Chart - Efco D - BC Manual De Instrucciones

Using Troubleshooting Chart

WARNING: Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
When you have checked all the possible causes listed and you are still experiencing the problem,
see your Servicing Dealer. If you are experiencing a problem that is not listed in this chart, see your
Servicing Dealer for service.
PROBLEM
Cutting attachment running incorrectly
and with high vibration
Engine starts and runs, but cutting
attachment is not rotating
WARNING: Never touch the
blade while the engine is
running.

TROUBLESHOOTING

POSSIBLE CAUSE
1. Cutting attachment damaged.
2. Cutting attachment
assembled.
1. Cutting attachment
assembled.
2. Bevel gear damaged.
3. Clutch drum damaged.
SOLUTION
1. Replace the cutting attachment.
incorrectly 2. Reassemble the cutting attachment
with care.
incorrectly 1. Refer to Assembly-Assembling the
cutting attachment Section.
2. Replace if necessary - contact a
Servicing Dealer.
3. Replace if necessary - contact a
Servicing Dealer.
en
21