Publicidad
Idiomas disponibles
Idiomas disponibles
Different materials and components may respond
differently to wear and stress fatigue. If a component
has exceeded its designed lifespan, it may fail
unexpectedly and potentially cause harm to the
rider. Therefore, any signs of cracks, scratches, or
color changes in highly stressed areas indicate that
the component has reached the end of its lifespan
and should be replaced immediately.
Local laws
Rules for electric bikes vary depending on the rider's
location. In some places, they follow the same rules
as regular bikes. However, different areas may have
specific laws for electric bikes, including licenses, age
limits, where you can ride, and required equipment
such as helmets. The rider should know and follow the
regulations that apply to electric bikes in their area.
2.3
SAVE THESE INSTRUCTIONS
2.4
FCC REQUIREMENT
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
WARNING
ANY CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE COULD VOID
THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT AND ITS WARRANTY.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
English (Original Instructions)
3
ASSEMBLY
This section describes how to assemble and adjust the
product.
WARNING
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
3.1
INSTALL THE HANDLEBAR
1. Rotate the handlebar stem 180° to face it forward.
180°
2. Use three bolts to tighten and secure the stem in
position.
3. Unscrew 4 bolts from the stem cover.
9
EN
Publicidad
