GE Profile 23 Manual Del Propietario E Instalación página 23

Installation Instructions
BEFORE YOU BEGIN
ROLLERS (CONT.)
To adjust the rollers on 23' models:
@ P.emox e the base _ofille b', oi)ening, the dom_
removing the screws at each end, and pulling
it straight out.
_Tum the fl'ont roller ______
ac!iusting screws
dockwise to raise the
refl_igeratm;
comaterdockwise to
lower it. Use a 3/8"
hex socket
or wI'ench,
or an a({iustable
wI'ench, " '
@ These models also have rear a(!justable rolle_5 so w,u
can align the refrigerator with vom" kitchen cabinets.
Llse a long-handled 5/16" socket wrench to turn the
screws t0r the rear rolle_5-dockwise to raise the
refl_igeratm; comlterclockwise to lower it.
Replace the base grille.
DOOR ALIGNMENT
_Mter leveling, make sm'e that dom_ are even at tile top.
To make the doors even, adjust the refl_igerator doo_:
@ Usnlg a 1/16 socket wrench, tuln the dora adlustnlg
screw to the right to raise tile doo_, to tile left to
lower it. (A nflon plug, imbedded in the threads ot
tile pin, prevents tile pin fl'om tm'ning tmless a
wrench is used.)
@ _&JieI" one oi" two ttlI'ns of
tile
wI'ench, open _lIld
close
the refl_igerator door and check the alignment at the
top of tile (lomb.
Toremove the base
grille,openthe doors,
remove the screwat
eachendof the base
grilleandthenpullthe
grillestraightout.
7/16" Socket W rench
2
Raise
23
DIMENSION AND SPECIFICATIONS
(for CustomStyle
TM
models)
O O
7!1/4 "
(178.4 cm)
36"
(91.4cm)
24"
(61cm)
24"
(61cm)
Cabinet
L "
3/4 (19mm)Airspace
(1/2"(13mm)Gap +
1/4"(6 mm) W allPlates)
' J'L
25" (63.5cm)
Countertop