Nolan X Serie Seguridad E Instrucciones página 27

3 DISASSEMBLING THE CHIN STRAP COVERING
To remove the chin strap covering from the strap, proceed as follows after removing the
cheek pads from the helmet (see instructions above).
3.1 Pull the left covering strap at the snap button to separate it from the chin strap
band and then pull it out of it (Fig.21A).
3.2 Follow these operations with the right strap covering.
4 DISASSEMBLING THE LINER
4.1 Release the left rear tab of the liner from the shell rear edge by slightly pulling the
comfort padding inwards (Fig.22). Then follow the same operation with right rear
tab.
4.2 Pull the comfort padding rear towards the inside of the helmet to release the two
side buttons located at its rear from their housings on the rear support, which is
fixed to the polystyrene inner shell (Fig.23).
4.3 Hold the liner left front and pull it upwards in order to remove the corresponding
liner tab from the support fixed to the polystyrene inner shell (Fig.24). Then follow
the operation with central front and right tabs.
4.4 Completely remove the comfort padding from the helmet.
5 ASSEMBLING THE LINER
5.1 Insert the liner properly into the helmet and have it well fitted against the base.
5.2 Insert the liner left front tab into the corresponding housing on the support fixed to
the polystyrene inner shell and push it downwards until it is completely fastened.
Then follow the operation with central and right tabs (Fig.24).
5.3 Fasten the two side buttons on the back of the comfort padding rear part to the
their corresponding housings on the rear support fixed to the polystyrene inner
shell (Fig.23).
5.4 Insert the liner rear right and left tabs into their corresponding housings of the shell
edge (Fig.22). Push the tabs until they are fully fastened onto the support.
6 ASSEMBLING THE CHIN STRAP COVERING
The right and left chin strap coverings are different from each other (Fig.21B).
6.1 After identifying the left covering strap, slide the chin strap release mechanism
onto the free end of the chin strap that features a snap button until it comes com-
pletely out from the central slot. Press the free end of the strap over the chin strap
band at the snap button and fasten it to the strap (Fig.21A).
6.2 Follow these operations with the right strap covering.
6.3 Check that the straps are secured by gently pulling them towards the inside of the
helmet.
6.4 If the release mechanism is the D-Ring type, check that the anti-fluttering snap
button on the left strap only is correctly placed past the two "D-rings" (Fig.21B).
7 ASSEMBLING THE INNER EXPANDING FOAM PADDING OF THE CHEEK PADS
7.1 Gently insert the inner expanding foam padding inside the left cheek pad fabric lin-
ing (Fig.20). Carefully stretch the padding while checking that there are no creases
in the cheek pad fabric lining.
7.2 Follow these operations with the right cheek pad padding.
INSTRUCTIONS FOR USE
X-804
25