Publicidad
Idiomas disponibles
Idiomas disponibles
EnGLIsH
Operating the Pruner (Fig. A)
WARNING: Read and understand all instructions. Failure
to follow all instructions listed below may result in electric
shock, fire and/or serious personal injury.
•
Guard Against Kickback which can result in severe
injury or death. See Important Safety Instructions
causes and Operator Prevention of kickback, to
avoid the risk of kickback.
•
Do not overreach. Do not cut above chest height.
Make sure your footing is firm. Keep feet apart. Divide
your weight evenly on both feet.
•
Use a firm grip with your left hand on the front
handle
15
and your right hand on the rear
handle
14
so that your body is to the left of the
guide bar.
WARNING: Do not hold pruner by front hand guard.
Keep elbow of left arm locked so that left arm is straight to
withstand a kickback.
WARNING: Never use a cross-handed grip (left hand on
the rear handle and right hand on the front handle).
WARNING: Never allow any part of your body to be in line
with the guide bar when operating the pruner.
•
Never operate pruner while in a tree, in any awkward
position or on a ladder or other unstable surface. You
may lose control of pruner causing severe injury.
•
Keep the pruner running at full speed the entire time
you are cutting.
•
Allow the chain to cut for you. Exert only light pressure.
Do not put pressure on pruner at end of cut.
WARNING: When not in use always have the chain
brake (if equipped) engaged, unit turned off and
remove the battery pack.
WARNING: Never operate the pruner without the
bar tip guard properly mounted on the guide bar to
prevent rotational kickback.
ON/OFF Switch (Fig. A)
WARNING: Never attempt to lock a switch in the
ON position.
Always be sure of your footing and grip the pruner firmly with
both hands with the thumb and fingers encircling both handles.
1. To turn the unit on, push down on the lock-off lever
shown in Fig. A, and squeeze the trigger switch
unit is running, you may release the lock-off lever.
2. To keep the unit running you must continue to squeeze the
trigger switch
1
.
3. To turn the unit off, release the trigger switch
48
nOTE: If too much force is applied while making a cut the
pruner will turn off. To restart pruner, you must release the
lock-off lever
restart. Begin your cut again, this time with less force. Allow the
pruner to cut at its own pace.
Common Cutting Techniques
Limbing
Removing the branches from a fallen tree. When limbing, leave
larger lower limbs to support the log off the ground. Remove
the small limbs in one cut. Branches under tension should be
cut from the bottom of the branch towards the top to avoid
binding the pruner as shown below. Trim limbs from opposite
side keeping tree stem between you and pruner. Never make
cuts with pruner between your legs or straddle the limb to
be cut.
Bucking
Cutting a felled tree or log into lengths. How you should
cut depends on how the log is supported. Use a saw horse
whenever possible as shown below.
2
,
1
. Once the
1. Always start a cut with the pruner chain running at
full speed.
2. Place the ribbed bumper
of the initial cut as shown below.
1
.
3. Turn the pruner on then rotate the pruner chain and bar
down into the tree, using the ribbed bumper as a hinge.
4. Once the pruner gets to a 45 ° angle, level the pruner again
and repeat steps until you cut fully through.
2
and the trigger switch
WARNING: Recommend that first-time users should
practice cutting on a pruner horse.
21
of the pruner behind the area
1
before the pruner will
Publicidad
