ELICA VOLTA EIV424BL Guía De Instalación, Uso Y Mantenimiento página 16

USER SERVICING AND MAINTENANCE INSTRUCTIONS
I
CAUTION
Before any cleaning or maintenance, make sure the cooking zones are switched off and the heat indicator has turned off.
CLEANING
The cooktop must be cleaned after each use.
I
IMPORTANT
• Do not use abrasive sponges, scouring pads. Their use, over time, may ruin the glass.
• Do not use chemical irritants, such as oven sprays or stain removers.
• After each use, leave the cooktop to cool and clean it to remove deposits and stains caused by food residue.
• Sugar or food with a high sugar content damages the hob and must be immediately removed.
• Salt, sugar and sand may scratch the glass surface.
• Use a soft cloth, paper towel or specific products to clean the cooktop (follow the Manufacturer's instructions).
DO NOT USE STEAM JET CLEANERS
TROUBLESHOOTING
Information Code
+
Acoustic signal
For all other error signals
(E...U...)
Customer Service
Before contacting Customer Service
1. Check that you cannot solve the problem yourself based on the points described in "Troubleshooting".
2. Switch the device off and on again to see if the problem resolves itself.
If the fault persists after the above checks, contact the nearest Customer Service.
Induction hob: EIV424BL
Rated Voltage: 220 V~
Frequency: 60 Hz
Power consumption: 6.1 kW
Current consumption: 28 A
Content: 1 piece.
Made in Mexico
Manufactured by: ELICAMEX S.A. de C.V.
Address: Av. La Noria (Prolongación) No. 102,
Col. Ampliación Parque Industrial Querétaro,
Santa Rosa Jáuregui, C.P. 76215, Querétaro, México.
R.F.C. ELI060102RK8
Description
The command zone switches off
due to an excessively high tempe-
rature.
Continuous (permanent) key ac-
tivation is detected. The interface
switches off after 10 seconds.
Call customer service and report the error code.
Possible Causes
The temperature inside the
electronic parts is too high.
Water, pots or kitchen tools
are on top of the user inter-
face.
16
Solution
Wait for the cooktop to
cool before reusing it.
Clean the surface, remo-
ve any objects from the
surface.