Garant ST2 Manual De Uso página 75

11. Cleaning
Remove dirt using a soft, clean and dry cloth. After contact with liquids, dry mechanical parts well. Do not use chemical, al-
cohol-based, abrasive or solvent-based cleaners.
12. Storage
Store in an enclosed dry room.
Do not store in the vicinity of acidic, aggressive, chemical substances, solvents, humidity and dirt.
i
To conserve the battery, it is recommended that the storage temperature does not exceed 30 °C.
13. Recycling and disposal
Do not dispose of the roughness measuring device and the battery with domestic waste.
Comply with the national regulations for disposal. Users have an obligation to take batteries, rechargeable
batteries and the roughness measuring device to a suitable collection point.
Observe the national and regional environmental and disposal regulations for proper disposal or recycling.
Separate metals, non-metals, composite materials and additives by type and dispose of them in an environ-
mentally responsibly way.
14. Technical data
Roughness measuring device
Data
Unit of measurement
Measurement principle
Probe
Probe tip
Probe tip angle
Measuring force
Measuring range
Profile resolution
Display
Parameters
Filter
Standards
Cutoff λc (as per ISO / JIS)
Pre-travel
Post-travel
Traversing lengths t (as per ISO / JIS)
Traversing length (as per MOTIF)
Total traversing lengths Im (as per ISO / JIS)
Short cutoff (as per ISO / JIS)
Probe speed
Value
Metric / inch
Profile method
Inductive skid probe
2 µm
90 ⁰
0.75 Nm
350 µm
8 nm
4.3" - touch display, rotatable
Ra, Rq, Rz, (Ry (JIS) corresponds to Rz) Rz (JIS)
Rmax, Rp, RpA (ASME), Rpm (ASME), Rpk,
Rk, Rvk, Mr1, Mr2, A1, A2, Vo, Rt, R3z, RPc, Rmr, (tp (JIS, ASME)
corresponds to Rmr), RSm, RSK, RS, CR, CF, CL, R, Ar, Rx
Gaussian filter as per DIN EN ISO 16610-21
Special filter as per DIN EN ISO 13656-1
Ls filter as per DIN EN ISO 3274 (can be deactivated)
DIN EN ISO, ASME, JIS
0.25 mm, 0.8 mm, 2.5 mm; automatic
Half
None
1.5 mm, 4.8 mm, 15.0 mm,
N x Lc, freely selectable, automatic
1.00 mm, 4.00 mm, 8.00 mm, 12.00 mm, 16.00 mm
1.25 mm, 4.00 mm, 12.5 mm
Selectable, freely adjustable
1 mm / s, 0.5 mm / s
www.hoffmann-group.com
de
bg
da
en
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
75