Worx Nitro WX813 Manual Original página 12

VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
surface
Vibration emission value
grinding or a
h,AG
abrasive
Uncertainty K = 1.5 m/s²
cutting off
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
12
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
Category
20V Battery
20V Charger
20V Cordless Brushless Angle Grinder
= 4.808 m/s
2
Model Capacity
WA3550
WA3550.1
WA3551 2.0Ah
WA3551.1 2.0Ah
WA3553 4.0Ah
WA3760
WA3869
WA3880
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When
replacing the battery
pack, do not insert the
battery until the Grinding/
Cutting Disc comes to a
complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting
Disc
1.5Ah
1.5Ah
0.4A
2.0A
2.0A
ACTION
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
See Fig. C1,
C2, C3
FIGURE
EN