Publicidad
Idiomas disponibles
Idiomas disponibles
5. CARE AND MAINTENANCE
Defrost
The defrost of your appliance is manual.
Defrost when frost is accumulated on the evaporator is about 2mm:
▪ Set the thermostat to "0" for defrosting.
▪ Switch off the appliance and disconnect the mains plug from the mains socket.
▪ Remove all contents.
▪ Leave the showcase door open to allow melting of the ice.
▪ Remove large pieces of ice if necessary, with dishcloth or something that will
not damage the walls.
▪ Do not use hot water or other electric heaters to melt the accumulated ice.
▪ After defrosting, remove the accumulated ice / water and dry with a soft cloth.
▪ Restart the unit according to the start instructions. Never use a knife or other
sharp instrument to scrape ice inside.
Cleaning inside the appliance
Before maintenance, switch off the appliance and disconnect the mains plug from the
mains socket. After defrosting you should clean the refrigerated showcase internally
with a weak solution of bicarbonate of soda. Then rinse with warm water using a damp
sponge or cloth and wipe dry. Wash the baskets in warm soapy water and ensure they
are completely dry before replacing in the refrigerated showcase. Condensation will
form on the back wall of the Refrigerated showcase; however, it will normally run down
the back wall and into the drain hole.
Cleaning outside the appliance
Before maintenance, switch off the appliance and disconnect the mains plug from the
mains socket. Use standard non-abrasive detergent diluted in warm water to clean the
refrigerated showcase exterior.
The grille of the condenser at the back of the refrigerated showcase and the adjacent
components can be vacuumed using a soft brush attachment.
Do not use harsh cleaners, scouring pads or solvents to clean any part of the
refrigerated showcase.
Moving the unit
▪ Transportation
Do not transport the device at an angle of less than 45° with the
ground. When loading, never stand on any of the external parts,
such as the door.
When the beverage cooler is installed or used, the desired
packaging (including cardboard and plastic foam) should be
removed.
Do not hold the handle when installing and moving the beverage cooler.
25
Publicidad
