WALCOM 360 TRUE LIGHT EVO Instrucciones página 7

Choose the reduction/adapter to apply inside appropriately of the LED ring,
checking that the light is firmly blocked on the ring.
For the expected coupling, check the updated table. Check here
If the rubber adapter is damaged or no longer functions clutch, replace it
with a new one.
INSTRUCTIONS FOR USE
Position the 360 TRUE LIGHT EVO light on the ring, making sure that the cap and the initial
portion of the ring are positioned completely outside the protective glass (fig.2) and not just
partially (fig.3).
Check that the 360 TRUE LIGHT EVO system is firmly locked to the aircap/ring.
(fig. 2)
It is suggested to position the body on the
opposite side to the hand being used (for
example for a right-handed person, posi-
tion the battery body on the left side of the
spraygun).
To turn on the light, press the power button;
the light will gradually reach the last inten-
sity set, otherwise, in the case of a partially
charged battery, it will reach the maximum
value allowed by the battery charge (lower
than the one previously set). To adjust the
light intensity, hold down the power button
(first ramp=increase in light intensity, second
ramp=reduce light intensity). The light main-
tains the set intensity even during subsequent
restarts.
To turn off the light, short press the power button.
Low battery: during operation, a brief flash of the LEDs means that the battery charge is not suf-
ficient to maintain the set brightness and therefore the light intensity is automatically reduced to
maintain the maximum brightness allowed by the remaining battery charge. To avoid flashing, you
can manually decrease the light intensity by holding down the power button.
Charging phase: before proceeding with charging, carefully read the SAFETY WARNINGS in order
to prevent personal damage, fires or accidental explosions.
Remove the protective cap of the USB-C connector and connect the supplied cable to the 360
TRUE LIGHT EVO light and to the USB power supply (5V and at least 1A).
During the charging phase the LEDs flash as follows:
- 1 flash every 5 seconds: battery charged from 0% ÷ 33%
- 2 flashes every 5 seconds: battery charged from 33% ÷ 66%
- 3 flashes every 5 seconds: battery charged from 66% ÷ 99%
The flashing stops when charging is complete; once charging is complete, remove the cable and
reinsert the USB protection cap into its seat.
Warning: if during the charging phase the light flashes constantly every 0.5 seconds, immediately
disconnect the battery charging cable and proceed to check the battery connections with the
metal connectors and the integrity/presence status of the battery.
(fig. 3)
Power button
Place for USB-C cable charging