WALCOM 360 TRUE LIGHT EVO Instrucciones página 9

SCHEDULED MAINTENANCE
Part
Cleaning the protective
glass support
Cleaning the body and
rubber reduction rings
Battery charging cycle
Check tightening screws
body/LED ring and cover/
body
OPERATING MALFUNCTIONS AND REMOVAL OF THE CAUSES
Problem
The light does not turn on Low battery
The light does not turn on
and does not charge
Battery life is reduced
The protective glass is
damaged
The light does not get
stuck in the airbrush
During the charging phase
the light flashes constantly
CARE, MAINTENANCE AND REMOVAL FROM SERVICE
In order to guarantee the functioning of the 360 TRUE LIGHT EVO light over time, carry out
cleaning and maintenance at regular intervals, scrupulously following the maintenance and
cleaning plan.
It is advisable to keep the protective glass and the internal glass of the LEDs clean, together with
regular care/maintenance and storage of the product.
Pay attention to the management of the battery, in terms of periodic charges and temperatures
of use: inconsistent use and with temperature peaks compromises the life of the battery and the
relative number of recharge cycles.
Follow local regulations/legislation for the disposal of the battery and the product when it is
taken out of service.
Operation
Clean the protective glass with a non-abrasive
cloth, moistened with a neutral pH detergent
solution (the Walcom Paint Remover Ref.
90261 kit is recommended)
Clean with a non-abrasive cloth, moistened
with a neutral pH detergent solution (we
recommend the Walcom Paint Remover kit
Ref. 90261)
Perform a complete charging cycle
Check that the body closing screws on the ring
and cover are correctly tightened
Causes
Battery does not make
contact with the metal
connectors or is inserted
incorrectly
Battery to be replaced
Ruined/scratched slide
Use of incorrect reduc-
tion;
The rubber reducer is
worn or damaged
Battery disconnected or
not working
9
Frequency
Every use
Every use
6 months
1 month
Solution
Charge the battery
Check that the metal connectors of
the battery holder are in contact with
the relevant battery poles and that the
battery is correctly inserted
Replace the battery
Replace the protective glass
Choose the size of the most suitable
rubber reduction;
Replace the reduction with a new one
Check that the metal connectors of the
battery holder are in contact with the
relevant battery poles and that the batte-
ry is correctly inserted
EN