Airzone Aidoo Zigbee AZAI6ZBE Serie Manual De Instrucciones página 13

Attributes
FanMode
FanModeSequence
#242 - Zigbee Green Power
Zigbee Green Power (ZGP) is included in the Zigbee 3.0 standard specification, It is an end-to-
end open standard that allows ultra-low power devices called Green Power Devices (GPDs) to
operate on Zigbee networks using ultra-low power RF transmiter that requires less power than
required for a Zigbee sleepy or fully-networked wireless connection.
RESET TO THE FACTORY SETTINGS
Please use this procedure only when the network primary controller is missing or ortherwise
inoperable.
The Aidoo Zigbee can be reset to the original factory settings by long pressing over the Factoy
Reset button until all of the front side LEDs light up for a second.
Note: If the reset is performed while the device is still part of a network, it notifies the other
devices in the Lifeline group that it has been removed.
FIRMWARE UPDATE
The Aidoo Zigbee supports over-the-air firmware updates that do not require the device to be
removed from its location. The firmware update can be activated from all certified controllers.
Important: The Aidoo Zigbee will be rebooted at the end of the firmware update
procedure. It is advisable to carry out the firmware update procedure only when necessary
and following careful planning of the intervention.
FAN CONTROL CLUSTER
Read (R) / Write (W)
Specifies the current fan speed.
Supported values are:
R / W
Specifies the available fan speeds that
R / W the thermostat can set.
Values
- 0x00 = OFF
- 0x01 = Low
- 0x02 = Medium
- 0x03 = High
- 0x04 = On
- 0x05 = Auto
- 0x02 = Low/Med/High/Auto
EN
13