Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING
THE WATER LINES
• IMPORTANT: Use new hoses when installing
the washer. Do NOT reuse old hoses.
• IMPORTANT: Use ONLY the inlet hoses provided
with this laundry product. Aftermarket hoses are not
guaranteed to fit or function correctly. Other hoses may
not tighten correctly and could cause leaks. Subsequent
damage to product or property will not be covered under
the terms of the product warranty.
• Water supply pressure must be between 14.5 PSI and
116 PSI (100~800 kPa). If the water supply pressure is
more than 116 PSI, a pressure reducing valve must be
installed.
• Periodically check the hose for cracks, leaks, and wear,
and replace the hose if necessary.
• Make sure that the water lines are not stretched,
pinched, crushed, or kinked.
• The washer should never be installed or stored in a
location subject to freezing temperatures.
Damage to
the water lines and internal mechanisms of the washer
can result. If the washer was exposed to freezing
temperatures prior to installation, allow it to stand at
room temperature for several hours before use and
check for leaks prior to operation.
f
Water Hose
(to water inlet
on washer)
X
Rubbe_rS17/
RubberSeal
I
0
Water Hose
(to tap)
1. Inspect the threaded fitting on each hose and make
sure there is a rubber seal in place in both ends.
J
f
Water
_,
Inlets
J
2. Attach the red, hot water line to the hot water inlet on
the back of the washer. Attach the blue, cold water line
to the cold water inlet on the back of the washer. Tighten
the fittings securely.
NOTE: Be careful not to cross-thread the hose fittings
since this will damage the valve and could result in property
damage from leaks.
Water Ta_
_
J
3. Attach the hot water line to the hot water tap. Attach the
cold water line to the cold water tap.
Tighten the fittings securely. Open the water taps fully and
check for leaks.
9
Publicidad
