Trevi SCD 5725 BT Manual De Uso Y Conexiones página 12

ENGLISH
When TP information gets lost at the current station for retune time which is set by
RETUNE SHORT(60 seconds) or RETUNE LONG(90 seconds), the radio start to
retune to next same PI station. When same PI station is not received in 1 cyclic
search, the radio retunes to next station with TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is not
activated. Only double beep sound(ALARM) is out-put.
When newly tuned station does not have TP information for 5 seconds, beeps are
sounded.
When TP information gets lost at the current station for retune time, the beep
sound is out-putted.
When newly tuned station has no RDS signal, PI SEEK may be suppressed.
(2) PI SOUND/ PI MUTE:
PI SOUND mode: If a car is cruising between buildings, an oscillation phenomenon
may occur, due to different PI codes being received from the same AF.
PI MUTE mode: In above situation, the sound will be muted for less than 1 second.
(3) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not received during retune time , the radio start to retune to
next same PI station.
When same PI station is not received during 1 cyclic search, the radio goes to last
station and waits for 4-5 minutes until PI code is received.
RETUNE L mode: selected as 90 seconds.
RETUNE S mode: selected as 60 seconds.
(4) MASK DPI/MASK ALL:
MASK DPI mode: masked only the AF which has different PI.
MASK ALL mode: masked the AF which has different PI and NO RDS signal with high
field strength.
BEEP ON mode: The beep is generated when any key is pressed.
BEEP OFF mode: The beep sound is disabled.
(6) VOL LAST/VOL DEFA
VOL LAST: The volume level when switching off will be restored with power On.
VOL DEFA: The volume level of the main unit after power on is a constant value.
when selecting VOL DEFA item, press SEL button to display AVOL , then
you can pre-set the constant volume level after power on with VOL control.
(7) CLK ON/OFF
CLK ON: Clock will always show on the display when power is off.
CLK OFF: Clock will disappear from the display when power is off.
6. To display and adjust clock
Press CLK button briefly to display time for 5 seconds on the display, and then
returns to its previous display unless the button is pressed again.
Press CLK button and hold for more than 1 second until the real time flashes on
LCD. Then you can adjust HOUR or MINUTE with volume control .
Page 3
12
SCD 5725 BT