Costway FH10063 Manual Del Usuario página 6

Assembly Instructions
3. Assembly Steps
7
6
5
3
6
7
4
1. Take the main unit out of the box and place it on a carpet
or soft cushion. As shown in step
part" into the corresponding position of the main frame in the
direction shown in the figure. At this time, grab the "rear leg"
with one hand and lift the "back" upwards with the other hand
until hearing a "click". At this time, it means that the "fixing
part" has been inserted into the corresponding hole of the
main unit. After that, you can directly pull the "fixing part"
outward, and then move the "back" to the desired direction,
and release the "fixing part", and then change the angle of
the back appropriately until you hear a "click";
2. As shown in step 2
rear leg to the corresponding position of the main frame. It
should be noted that the direction of the label on the rear leg
should be towards the upper and front of the main unit, and
the 2 circular foot pads should face down, otherwise the
screws cannot be screwed in.
10
8
1
above, screw the "fixing
1
above, use 2 M8X55 screws to fix the
3. As shown in step
front end of the "seat", insert 2 "M8X45 bolts" from the top,
then insert 2 "Ф9 flat washers" at the lower end, and screw in
the "M8 hexagon lock nut";
4. As shown in step
corresponding position of the "front support pipe" with 2
"M8X15 screws" ;
5. As shown in step
was previously screwed into the "Foot Support", insert the
assembly into the corresponding square hole of the "Front
Support Pipe" in the direction shown in the figure, and use "
2
Screw the "M10 knob" into the exposed screw rod of the
"Foot Support", and then tighten the "M10 knob";
6. As shown in step
"Foot Support" and "Front Support Pipe" respectively.
7. As shown in step
corresponding part of the "front leg" according to the direction
shown in the figure. First set the exposed bump of the "snap
hook" in the "handle" tube against the the "front leg", and
then use your thumb and index finger to press the exposed
bump of the "snap hook" into the tube until it is inserted
smoothly, until the exposed protruding point of the "snap
hook" is inserted into the socket of the "front leg", otherwise it
will cause a safety hazard;
8. As shown in step
"back", 2 M8X45 bolts" need to be inserted from the top, the
lower end of each into 2 "Ф9 flat washer" and then screw into
the "M8 nut";
Note: If the weight bench is unstable before use, please
adjust the foot pads to ensure stability.
After assembly, please double check that all bolts are
tightened.
3
above, insert the "front leg" into the
4
above, fasten the "front leg" to the
5 above, remove the "M10 knob"that
6
above, insert the 4 foams into the
7
above, insert the "handle" into the
8 figure, to insert the "seat" into the
11