GE AKH18 Manual Del Propietario Y Instrucciones De Instalación página 12

Installation instructions
[_ iNSTALL THE V-SUPPORTS (cont.)
For Windows With an Outside Sill (cont.):
FC-I Adjust sill angle brackets to rest on sill.
ForWindows Without an Outside Sill:
[] Assemble the V-support andType
E bolt with two nuts.
[]
@
@
Use a wood block (obtained
locally) between theType E
bolts and the wall if the wall
is weak or if the weight of the
air conditioner falls between
the studs in the wal!.
Adjust theType E bolts l_
and nuts against the
outside wal! so that
the case has a slight
tilt to the outside.
Tighten nuts with an
adjustable wrench. Use
a level; no more than a
1/2 bubble will be the correct case slant to
the outside.
Extend the left and right accordion panels
to the vertical window sashes. Drill pilot
holes and attach the top and bottom
corners with 5 type B screws.
J
Type B
screw
Top mounting rail
and Type B screw
Type B
screw
Type B screw
and sash lock
Type B screw
and sash lock
[]
INSTALL SUPPORT BRACKET AND
FOAM TOP WINDOW GASKET
CAUTION:
To prevent broken glass
or damage to windows,
on vinyl or other
similarly constructed
windows, attach the
window locking bracket
to the window side jamb.
Attach the window
locking bracket with one
Type B screw.
Vinyl
Wood
Cut the foam top window gasket to the
window width.
Stuff the foam
between the
glass and the
window to
prevent air and
insects from
getting into the room.
NOTE: If the gasket supplied does not fit
your window, obtain appropriate material
locally to provide a proper installation seal.
12